Re: [PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation

[Marco Felsch]

On 19-12-12 16:51, Mark Brown wrote:
> On Thu, Dec 12, 2019 at 05:21:53PM +0100, Marco Felsch wrote:
> 
> > "... what's driving the input ..":
> > Sorry I didn't get you here. What did you mean? The input is driven by
> > the host. This can be any gpio line and in my case it is a gpio line
> > driven by the soc-hw during a suspend operation.
> 
> Something needs to say what that thing is, especially if it's runtime
> controllable.  In your case from the point of view of software there is
> actually no enable control so we shouldn't be providing an enable
> operation to the framework.

The enabel control signal is always available, please check [1] table
63. There is a mux in front of the enable pin so:

             +-------------
 Seq. |\     |   Regulator
 GPI1 | \    |
 GPI2 | | -- > Enable
 GPI3 | /    |
      |/     .
             .
             .

Adam please correct me if this is wrong.

[1] https://www.dialog-semiconductor.com/sites/default/files/da9062_datasheet_3v6.pdf

Regards,
  Marco

> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel