[PATCH net-next v2 5/8] net: bcmgenet: Utilize bcmgenet_set_features() during resume/open

[Doug Berger]

During driver resume and open, the HW may have lost its context/state,
utilize bcmgenet_set_features() to make sure we do restore the correct
set of features that were previously configured.

Signed-off-by: Doug Berger <opendmb@xxxxxxxxx>
Reviewed-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
 drivers/net/ethernet/broadcom/genet/bcmgenet.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index 811713e3d230..0e57effd5b19 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -2884,6 +2884,11 @@ static int bcmgenet_open(struct net_device *dev)
 
 	init_umac(priv);
 
+	/* Apply features again in case we changed them while interface was
+	 * down
+	 */
+	bcmgenet_set_features(dev, dev->features);
+
 	bcmgenet_set_hw_addr(priv, dev->dev_addr);
 
 	if (priv->internal_phy) {
@@ -3687,6 +3692,9 @@ static int bcmgenet_resume(struct device *d)
 	genphy_config_aneg(dev->phydev);
 	bcmgenet_mii_config(priv->dev, false);
 
+	/* Restore enabled features */
+	bcmgenet_set_features(dev, dev->features);
+
 	bcmgenet_set_hw_addr(priv, dev->dev_addr);
 
 	if (priv->internal_phy) {
-- 
2.7.4