Re: [PATCH v1 0/3] Tegra GPIO: Minor code clean up

From: Dmitry Osipenko
Date: Thu Dec 19 2019 - 10:26:13 EST


19.12.2019 17:53, Thierry Reding ÐÐÑÐÑ:
> On Sun, Dec 15, 2019 at 09:30:44PM +0300, Dmitry Osipenko wrote:
>> Hello,
>>
>> I was investigating why CPU hangs during of GPIO driver suspend and in
>> the end it turned out that it is a Broadcom WiFi driver problem because
>> it keeps OOB wake-interrupt enabled while WLAN interface is DOWN and this
>> may cause a bit weird CPU hang on writing to INT_ENB register during of
>> GPIO driver suspend. Meanwhile I also noticed that a few things could be
>> improved in the driver, that's what this small series addresses.
>>
>> Dmitry Osipenko (3):
>> gpio: tegra: Use generic readl_relaxed/writel_relaxed accessors
>> gpio: tegra: Properly handle irq_set_irq_wake() error
>> gpio: tegra: Use NOIRQ phase for suspend/resume
>>
>> drivers/gpio/gpio-tegra.c | 21 ++++++++++-----------
>> 1 file changed, 10 insertions(+), 11 deletions(-)
>
> Patches look good:
>
> Reviewed-by: Thierry Reding <treding@xxxxxxxxxx>
>
> I also applied this series on top of v5.5-rc1 and ran it through our
> test system:
>
> Test results:
> 13 builds: 13 pass, 0 fail
> 22 boots: 22 pass, 0 fail
> 34 tests: 34 pass, 0 fail
>
> Linux version: 5.5.0-rc1-g3d0b4fced39e
> Boards tested: tegra124-jetson-tk1, tegra186-p2771-0000,
> tegra194-p2972-0000, tegra20-ventana,
> tegra210-p2371-2180, tegra30-cardhu-a04
>
> All tests passing, so:
>
> Tested-by: Thierry Reding <treding@xxxxxxxxxx>
>

Thank you very much!