Re: [PATCH v2 3/4] Bluetooth: hci_qca: Enable power off/on support during hci down/up for QCA Rome

[Marcel Holtmann]

Hi Rocky,

> This patch registers hdev->shutdown() callback and also sets
> HCI_QUIRK_NON_PERSISTENT_SETUP for QCA Rome. It will power-off the BT chip
> during hci down and power-on/initialize the chip again during hci up.
> 
> Signed-off-by: Rocky Liao <rjliao@xxxxxxxxxxxxxx>
> ---
> 
> Changes in v2: None
> 
> drivers/bluetooth/hci_qca.c | 5 +++++
> 1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
> index 45042aa27fa4..7e202041ed77 100644
> --- a/drivers/bluetooth/hci_qca.c
> +++ b/drivers/bluetooth/hci_qca.c
> @@ -1300,6 +1300,11 @@ static int qca_setup(struct hci_uart *hu)
> 	} else {
> 		bt_dev_info(hdev, "ROME setup");
> 		if (hu->serdev) {
> +			/* Enable NON_PERSISTENT_SETUP QUIRK to ensure to
> +			 * execute setup for every hci up.
> +			 */
> +			set_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks);
> +			hu->hdev->shutdown = qca_power_off;

why are you setting it in the ->setup callback and not in the ->probe callback?

Regards

Marcel