Re: [PATCH 2/2] dmaengine: uniphier-xdmac: Add UniPhier external DMA controller driver

[Vinod Koul]

On 18-12-19, 09:57, Kunihiko Hayashi wrote:
> This adds external DMA controller driver implemented in Socionext
> UniPhier SoCs. This driver supports DMA_MEMCPY and DMA_SLAVE modes.
> 
> Since this driver does not support the the way to transfer size
> unaligned to burst width, 'src_maxburst' or 'dst_maxburst' of

You mean driver does not support any unaligned bursts?

> +static int uniphier_xdmac_probe(struct platform_device *pdev)
> +{
> +	struct uniphier_xdmac_device *xdev;
> +	struct device *dev = &pdev->dev;
> +	struct dma_device *ddev;
> +	int irq;
> +	int nr_chans;
> +	int i, ret;
> +
> +	if (of_property_read_u32(dev->of_node, "dma-channels", &nr_chans))
> +		return -EINVAL;
> +	if (nr_chans > XDMAC_MAX_CHANS)
> +		nr_chans = XDMAC_MAX_CHANS;
> +
> +	xdev = devm_kzalloc(dev, struct_size(xdev, channels, nr_chans),
> +			    GFP_KERNEL);
> +	if (!xdev)
> +		return -ENOMEM;
> +
> +	xdev->nr_chans = nr_chans;
> +	xdev->reg_base = devm_platform_ioremap_resource(pdev, 0);
> +	if (IS_ERR(xdev->reg_base))
> +		return PTR_ERR(xdev->reg_base);
> +
> +	ddev = &xdev->ddev;
> +	ddev->dev = dev;
> +	dma_cap_zero(ddev->cap_mask);
> +	dma_cap_set(DMA_MEMCPY, ddev->cap_mask);
> +	dma_cap_set(DMA_SLAVE, ddev->cap_mask);
> +	ddev->src_addr_widths = UNIPHIER_XDMAC_BUSWIDTHS;
> +	ddev->dst_addr_widths = UNIPHIER_XDMAC_BUSWIDTHS;
> +	ddev->directions = BIT(DMA_DEV_TO_MEM) | BIT(DMA_MEM_TO_DEV) |
> +			   BIT(DMA_MEM_TO_MEM);
> +	ddev->residue_granularity = DMA_RESIDUE_GRANULARITY_BURST;
> +	ddev->max_burst = XDMAC_MAX_WORDS;
> +	ddev->device_free_chan_resources = uniphier_xdmac_free_chan_resources;
> +	ddev->device_prep_dma_memcpy = uniphier_xdmac_prep_dma_memcpy;
> +	ddev->device_prep_slave_sg = uniphier_xdmac_prep_slave_sg;
> +	ddev->device_config = uniphier_xdmac_slave_config;
> +	ddev->device_terminate_all = uniphier_xdmac_terminate_all;
> +	ddev->device_synchronize = uniphier_xdmac_synchronize;
> +	ddev->device_tx_status = dma_cookie_status;
> +	ddev->device_issue_pending = uniphier_xdmac_issue_pending;
> +	INIT_LIST_HEAD(&ddev->channels);
> +
> +	for (i = 0; i < nr_chans; i++) {
> +		ret = uniphier_xdmac_chan_init(xdev, i);
> +		if (ret) {
> +			dev_err(dev,
> +				"Failed to initialize XDMAC channel %d\n", i);
> +			return ret;

so on error for channel N we leave N-1 channels initialized?

> +static int uniphier_xdmac_remove(struct platform_device *pdev)
> +{
> +	struct uniphier_xdmac_device *xdev = platform_get_drvdata(pdev);
> +	struct dma_device *ddev = &xdev->ddev;
> +	struct dma_chan *chan;
> +	int ret;
> +
> +	/*
> +	 * Before reaching here, almost all descriptors have been freed by the
> +	 * ->device_free_chan_resources() hook. However, each channel might
> +	 * be still holding one descriptor that was on-flight at that moment.
> +	 * Terminate it to make sure this hardware is no longer running. Then,
> +	 * free the channel resources once again to avoid memory leak.
> +	 */
> +	list_for_each_entry(chan, &ddev->channels, device_node) {
> +		ret = dmaengine_terminate_sync(chan);
> +		if (ret)
> +			return ret;
> +		uniphier_xdmac_free_chan_resources(chan);

terminating sounds okayish but not freeing here. .ree_chan_resources()
should have been called already and that should ensure that termination
is already done...

-- 
~Vinod