[PATCH 4/6] spi: rspi: Remove set_config_register() macro

[Geert Uytterhoeven]

The set_config_register() macro is used in a single place.
Make the code easier to read by just removing it.

Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
 drivers/spi/spi-rspi.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index e54a25f848ea38c7..9eabef3d6cc478ff 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -426,8 +426,6 @@ static int qspi_set_receive_trigger(struct rspi_data *rspi, unsigned int len)
 	return n;
 }
 
-#define set_config_register(spi, n) spi->ops->set_config_register(spi, n)
-
 static void rspi_enable_irq(const struct rspi_data *rspi, u8 enable)
 {
 	rspi_write8(rspi, rspi_read8(rspi, RSPI_SPCR) | enable, RSPI_SPCR);
@@ -940,7 +938,7 @@ static int rspi_prepare_message(struct spi_controller *ctlr,
 	if (spi->mode & SPI_LOOP)
 		rspi->sppcr |= SPPCR_SPLP;
 
-	set_config_register(rspi, 8);
+	rspi->ops->set_config_register(rspi, 8);
 
 	if (msg->spi->mode &
 	    (SPI_TX_DUAL | SPI_TX_QUAD | SPI_RX_DUAL | SPI_RX_QUAD)) {
-- 
2.17.1