Re: [PATCH V2 5/7] USB: serial: f81232: Set F81534A serial port with RS232 mode

[Johan Hovold]

Hi Peter,

Sorry about the late reply. Had a change to look into this again today.

On Thu, Oct 24, 2019 at 04:52:01PM +0800, Ji-Ze Hong (Peter Hong) wrote:
> Hi Johan,
> 
> Johan Hovold æ 2019/10/23 äå 07:53 åé:
> > On Mon, Sep 23, 2019 at 10:24:47AM +0800, Ji-Ze Hong (Peter Hong) wrote:
> >> The Fintek F81532A/534A/535/536 is USB-to-2/4/8/12 serial ports device
> >> and the serial ports are default disabled. Each port contains max 3 pins
> >> GPIO and the 3 pins are default pull high with input mode.
> >>
> >> When the serial port had activated (running probe()), we'll transform the
> >> 3 pins from GPIO function publicly to control Tranceiver privately use.
> > 
> > I'm not sure I understand what you're saying here.
> > 
> >> We'll default set to 0/0/1 for control transceiver to RS232 mode.
> >>
> >> Otherwise, If the serial port is not active, the 3 pins is in GPIO mode
> >> and controlled by global GPIO device with VID/PID: 2c42/16f8.
> > 
> > Does this mean that you can control the three GPIOs either through the
> > serial device or through the gpio-control device (which are two separate
> > USB devices)?
> 
> Yes, when 1 F81534A connect to Host, it'll report device as following.
> 	virtual HUB
> 		GPIO Device.
> 		serial port 1
> 		...
> 		serial port n

Could you post lsusb -v output for this with a couple of UARTs enabled?

> The link are F81534A pin-out:
> 	https://imgur.com/a/AZHqQ1N

Do you have a datasheet for the device?

I think I'm starting to get an idea of how this work, but I really don't
like having to spend this much time on detective work just to understand
how the hw works.

> So we can control F81534A series all GPIO pins via GPIO Device.
> Serial ports are also control MODE0_x,  MODE1_x,  MODE2_x
> (e.g. UART1 MODE0_1,  MODE1_1,  MODE2_1), but when Serial ports
> is h/w disabled (DTR pull low), the mode pin will change to GPIO pin.

So you tie a ports DTR pin, even though it's normally an output, and use
that at boot to determine whether the UART should be enabled or not?

And the GPIO device can only control a pin if the corresponding port is
disabled?

Can you read back the enable state of each port?

> > Ok, so you reset the tranceiver config on every probe.
> > 
> > Are the three GPIOs always connected to one particular tranceiver, or
> > are they truly general purpose?
> > 
> > In the latter case, it doesn't seem like a good idea to drive pins 0
> > and 1 low here as you have know idea what they're used for.
> 
> If we want to change the mode pin to GPIO pin, it need do h/w disable.
> It the serial ports are activated, the 3 pin will be mode pin and set
> default 0/0/1 to RS232 mode due to this driver not implement RS422/485
> currently.

What about devices using a different tranceiver? Should the state of the
mode pins ultimately be tied to VID/PID (can your customers change
VID/PID)?

Johan