Re: [PATCH 1/1] mtd: spinand: Add support for new Micron SPI NAND devices

[Miquel Raynal]

Hi Shiva,

shiva.linuxworks@xxxxxxxxx wrote on Mon,  9 Dec 2019 07:42:23 +0100:

> From: Shivamurthy Shastri <sshivamurthy@xxxxxxxxxx>
> 
> Add device table for new Micron SPI NAND devices. While at it, add
> support to the multi-die selection. Also, generalize the OOB layout
> structure and function names.

Sorry for the delay. I am fine with this patch mostly, but could we
split it please?

O/ Disable continuous read feature (one typo, see below). I think this
might be considered as a fix.

1/ Generalize the OOB layout structure and function names.
2/ Add support for all the parts.
3/ Add multi-die support (one comment below about that).

As a general rule of thumb, small patches, doing one logic change are
much easier and quick to review and accept.


> +static int micron_select_target(struct spinand_device *spinand,
> +				unsigned int target)
> +{
> +	struct spi_mem_op op = SPINAND_SET_FEATURE_OP(0xd0,
> +						      spinand->scratchbuf);
> +
> +	if (target == 1)
> +		*spinand->scratchbuf = 0x40;

Please define 0x40 and explain clearly with a comment that this is
multi-die selection.

> +
> +	return spi_mem_exec_op(spinand->spimem, &op);
> +}
> +

[...]

> +static int micron_spinand_init(struct spinand_device *spinand)
> +{
> +	/*
> +	 * M70A series device enables Continuos Read feature on Power-up,
> +	 * which is not supported here. Making this BIT disable will avoid
> +	 * any possible failure.

What about:

           M70A device series enable Continuous Read feature at
           power-up, which is not supported. Disable this bit to
	   avoid any possible failure.

> +	 */
> +	return spinand_upd_cfg(spinand, CFG_QUAD_ENABLE, 0);
> +}
> +
>  static const struct spinand_manufacturer_ops micron_spinand_manuf_ops = {
>  	.detect = micron_spinand_detect,
> +	.init = micron_spinand_init,
>  };
>  
>  const struct spinand_manufacturer micron_spinand_manufacturer = {

Thanks,
MiquÃl