Re: [PATCH] ata: pxa: Use dma_request_chan() instead dma_request_slave_channel()

[Bartlomiej Zolnierkiewicz]

On 12/17/19 8:40 AM, Peter Ujfalusi wrote:
> dma_request_slave_channel() is a wrapper on top of dma_request_chan()
> eating up the error code.
> 
> By using dma_request_chan() directly the driver can support deferred
> probing against DMA.
> 
> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>

Acked-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>

Best regards,
--
Bartlomiej Zolnierkiewicz
Samsung R&D Institute Poland
Samsung Electronics

> ---
>  drivers/ata/pata_pxa.c | 7 +++----
>  1 file changed, 3 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/ata/pata_pxa.c b/drivers/ata/pata_pxa.c
> index 41430f79663c..71678bed04b0 100644
> --- a/drivers/ata/pata_pxa.c
> +++ b/drivers/ata/pata_pxa.c
> @@ -274,10 +274,9 @@ static int pxa_ata_probe(struct platform_device *pdev)
>  	/*
>  	 * Request the DMA channel
>  	 */
> -	data->dma_chan =
> -		dma_request_slave_channel(&pdev->dev, "data");
> -	if (!data->dma_chan)
> -		return -EBUSY;
> +	data->dma_chan = dma_request_chan(&pdev->dev, "data");
> +	if (IS_ERR(data->dma_chan))
> +		return PTR_ERR(data->dma_chan);
>  	ret = dmaengine_slave_config(data->dma_chan, &config);
>  	if (ret < 0) {
>  		dev_err(&pdev->dev, "dma configuration failed: %d\n", ret);
>