Re: [PATCH] ARM: dts: bcm283x: Unify CMA configuration

[Florian Fainelli]

On Fri, 10 Jan 2020 18:29:35 +0100, Nicolas Saenz Julienne <nsaenzjulienne@xxxxxxx> wrote:
> With the introduction of the Raspberry Pi 4 we were forced to explicitly
> configure CMA's location, since arm64 defaults it into the ZONE_DMA32
> memory area, which is not good enough to perform DMA operations on that
> device. To bypass this limitation a dedicated CMA DT node was created,
> explicitly indicating the acceptable memory range and size.
> 
> That said, compatibility between boards is a must on the Raspberry Pi
> ecosystem so this creates a common CMA DT node so as for DT overlays to
> be able to update CMA's properties regardless of the board being used.
> 
> Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@xxxxxxx>
> ---

Applied to devicetree/next, thanks!
--
Florian