[RESEND][PATCH 2/2] usb: hub: use non-removable-ports DT property

[Mans Rullgard]

Mark any ports listed in the non-removable-ports DT property as
hardwired. This is useful for boards with built-in USB devices
that cannot be (or have not been) marked as fixed in hardware.

Signed-off-by: Mans Rullgard <mans@xxxxxxxxx>
---
 drivers/usb/core/hub.c | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 4ac74b354801..97f8f15fb632 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -1366,6 +1366,9 @@ static int hub_configure(struct usb_hub *hub,
 	unsigned unit_load;
 	unsigned full_load;
 	unsigned maxchild;
+	struct property *prop;
+	const __be32 *cur;
+	u32 val;
 
 	hub->buffer = kmalloc(sizeof(*hub->buffer), GFP_KERNEL);
 	if (!hub->buffer) {
@@ -1667,6 +1670,19 @@ static int hub_configure(struct usb_hub *hub,
 		}
 	}
 
+	of_property_for_each_u32(hub_dev->of_node, "non-removable-ports",
+				 prop, cur, val) {
+		if (val < 1 || val > hdev->maxchild) {
+			dev_warn(hub_dev,
+				 "bad port number %u in non-removable-ports\n",
+				 val);
+			continue;
+		}
+
+		hub->ports[val - 1]->connect_type =
+			USB_PORT_CONNECT_TYPE_HARD_WIRED;
+	}
+
 	usb_hub_adjust_deviceremovable(hdev, hub->descriptor);
 
 	hub_activate(hub, HUB_INIT);
-- 
2.25.0