[PATCH] mtd: rawnand: denali: deassert write protect pin

[Masahiro Yamada]

If the write protect signal from this IP is connected to the NAND
device, this IP can handle the WP# pin via the WRITE_PROTECT
register.

The Denali NAND Flash Memory Controller User's Guide describes
this register like follows:

  When the controller is in reset, the WP# pin is always asserted
  to the device. Once the reset is removed, the WP# is de-asserted.
  The software will then have to come and program this bit to
  assert/de-assert the same.

    1 - Write protect de-assert
    0 - Write protect assert

The default value is 1, so the write protect is de-asserted after
the reset is removed. The driver can write to the device unless
someone has explicitly cleared register before booting the kernel.

The boot ROM of some UniPhier SoCs (LD4, Pro4, sLD8, Pro5) is the
case; the boot ROM clears the WRITE_PROTECT register when the system
is booting from the NAND device, so the NAND device becomes read-only.

Set it to 1 in the driver in order to allow the write access to the
device.

Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx>
---

 drivers/mtd/nand/raw/denali.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/mtd/nand/raw/denali.c b/drivers/mtd/nand/raw/denali.c
index fafd0a0aa8e2..6a6c919b2569 100644
--- a/drivers/mtd/nand/raw/denali.c
+++ b/drivers/mtd/nand/raw/denali.c
@@ -1317,6 +1317,7 @@ int denali_init(struct denali_controller *denali)
 	iowrite32(CHIP_EN_DONT_CARE__FLAG, denali->reg + CHIP_ENABLE_DONT_CARE);
 	iowrite32(ECC_ENABLE__FLAG, denali->reg + ECC_ENABLE);
 	iowrite32(0xffff, denali->reg + SPARE_AREA_MARKER);
+	iowrite32(WRITE_PROTECT__FLAG, denali->reg + WRITE_PROTECT);
 
 	denali_clear_irq_all(denali);
 
-- 
2.17.1