Re: [PATCH net-master 1/1] net: phy: dp83867: Add speed optimization feature

[Dan Murphy]

Florian

On 1/31/20 11:49 AM, Florian Fainelli wrote:
> On 1/31/20 7:11 AM, Dan Murphy wrote:
> > Set the speed optimization bit on the DP83867 PHY.
> > This feature can also be strapped on the 64 pin PHY devices
> > but the 48 pin devices do not have the strap pin available to enable
> > this feature in the hardware.  PHY team suggests to have this bit set.
> OK, but why and how does that optimization work exactly?

I described this in the cover letter. And it is explained in the data 
sheet Section 8.4.6.6

>   Departing from
> the BMSR reads means you possibly are going to introduce bugs and/or
> incomplete information. For instance, you set phydev->pause and
> phydev->asym_pause to 0 now, is there no way to extract what the link
> partner has advertised?

I was using the marvel.c as my template as it appears to have a separate 
status register as well.

Instead of setting those bits in the call back I can call the 
genphy_read_status then override the duplex and speed based on the 
physts register like below. This way link status and pause values can 
be updated and then we can update the speed and duplex settings.

 Â ret = genphy_read_status(phydev);
ÂÂ Âif (ret)
ÂÂ ÂÂÂ Âreturn ret;

ÂÂ Âif (status < 0)
ÂÂ ÂÂÂ Âreturn status;

ÂÂ Âif (status & DP83867_PHYSTS_DUPLEX)
ÂÂ ÂÂÂ Âphydev->duplex = DUPLEX_FULL;
ÂÂ Âelse
ÂÂ ÂÂÂ Âphydev->duplex = DUPLEX_HALF;

ÂÂ Âif (status & DP83867_PHYSTS_1000)
ÂÂ ÂÂÂ Âphydev->speed = SPEED_1000;
ÂÂ Âelse if (status & DP83867_PHYSTS_100)
ÂÂ ÂÂÂ Âphydev->speed = SPEED_100;
ÂÂ Âelse
ÂÂ ÂÂÂ Âphydev->speed = SPEED_10;


> > With this bit set the PHY will auto negotiate and report the link
> > parameters in the PHYSTS register and not in the BMCR.
> That should be BMSR, the BMCR is about control, not status.

OK.

Dan