Re: [PATCH v2] arm64: dts: qcom: sc7180: Add A618 gpu dt blob

[Jordan Crouse]

On Fri, Jan 31, 2020 at 08:08:09AM -0800, Doug Anderson wrote:
> Hi,
> 
> On Fri, Jan 31, 2020 at 4:16 AM <smasetty@xxxxxxxxxxxxxx> wrote:
> >
> > >> +                       reg = <0 0x0506a000 0 0x31000>, <0 0x0b290000
> > >> 0 0x10000>,
> > >> +                               <0 0x0b490000 0 0x10000>;
> > >> +                       reg-names = "gmu", "gmu_pdc", "gmu_pdc_seq";
> > >> +                       interrupts = <GIC_SPI 304
> > >> IRQ_TYPE_LEVEL_HIGH>,
> > >> +                                  <GIC_SPI 305 IRQ_TYPE_LEVEL_HIGH>;
> > >> +                       interrupt-names = "hfi", "gmu";
> > >> +                       clocks = <&gpucc GPU_CC_CX_GMU_CLK>,
> > >> +                              <&gpucc GPU_CC_CXO_CLK>,
> > >> +                              <&gcc GCC_DDRSS_GPU_AXI_CLK>,
> > >> +                              <&gcc GCC_GPU_MEMNOC_GFX_CLK>;
> > >> +                       clock-names = "gmu", "cxo", "axi", "memnoc";
> > >> +                       power-domains = <&gpucc CX_GDSC>;
> > >
> > > Bindings claim that you need both CX and GC.  Is sc7180 somehow
> > > different?  Bindings also claim that you should be providing
> > > power-domain-names.
> > No this is still needed, We need the GX power domain for GPU recovery
> > use cases where the shutdown was not successful.
> 
> This almost sounds as if the bindings should mark the GX power domain
> as optional?  The driver can function without it but doesn't get all
> the features?  As the binding is written right now I think it is
> "invalid" to not specify a a GX power domain and once the yaml
> conversion is done then it will even be flagged as an error.  That's
> going to make it harder to land the your patch...

For GMU attached targets the GX power domain is mandatory assuming you want to
recover successfully from a hard GMU hang, that is.

Jordan

-- 
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project