Re: [RFC-v2 0/2] Add Support for SDHC bus bandwidth voting

[ppvk]

Hi Matthias,

Will send my next series by end of this week.


Thanks and Regards,
Pradeep


On 2020-01-31 03:08, Matthias Kaehlcke wrote:
> Hi Pradeep,
>
> what is the status of this series, do you plan to send v3 soon or
> is it abandonded?
>
> Thanks
>
> Matthias
>
> On Fri, Nov 08, 2019 at 07:08:37PM +0530, Pradeep P V K wrote:
> > Vote for the MSM bus bandwidth required by SDHC driver
> > based on the clock speed and bus width of the card.
> > Otherwise, the system clocks may run at minimum clock
> > speed and thus affecting the performance.
> >
> > Adapt to the new ICB framework for bus bandwidth voting.
> >
> > This requires the source/destination port ids.
> > Also this requires a tuple of values.
> >
> > The tuple is for two different paths - from SDHC master
> > to BIMC slave. The other is from CPU master to SDHC slave.
> > This tuple consists of the average and peak bandwidth.
> >
> > This change is based on Georgi Djakov [RFC]
> > (https://lkml.org/lkml/2018/10/11/499)
> >
> > ---
> > changed since v1:
> > * Addressed all the Review comments.
> > * Minor code rebasing.
> >
> > Pradeep P V K (2):
> >   dt-bindings: mmc: sdhci-msm: Add Bus BW vote supported strings
> >   mmc: sdhci-msm: Add support for bus bandwidth voting
> >
> >  .../devicetree/bindings/mmc/sdhci-msm.txt          |  32 ++
> >  drivers/mmc/host/sdhci-msm.c                       | 366 
> > ++++++++++++++++++++-
> >  2 files changed, 395 insertions(+), 3 deletions(-)
> >
> > --
> > 1.9.1