Re: [PATCH v3 5/9] drm/bridge: ti-sn65dsi86: Read num lanes from the DP sink

[Bjorn Andersson]

On Wed 18 Dec 14:35 PST 2019, Douglas Anderson wrote:

> At least one panel hooked up to the bridge (AUO B116XAK01) only
> supports 1 lane of DP.  Let's read this information and stop
> hardcoding 4 DP lanes.
> 
> Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> Tested-by: Rob Clark <robdclark@xxxxxxxxx>
> Reviewed-by: Rob Clark <robdclark@xxxxxxxxx>

Reviewed-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>

> ---
> 
> Changes in v3: None
> Changes in v2: None
> 
>  drivers/gpu/drm/bridge/ti-sn65dsi86.c | 32 +++++++++++++++++++++++++--
>  1 file changed, 30 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi86.c b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
> index d55d19759796..0fc9e97b2d98 100644
> --- a/drivers/gpu/drm/bridge/ti-sn65dsi86.c
> +++ b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
> @@ -313,8 +313,7 @@ static int ti_sn_bridge_attach(struct drm_bridge *bridge)
>  		goto err_dsi_host;
>  	}
>  
> -	/* TODO: setting to 4 lanes always for now */
> -	pdata->dp_lanes = 4;
> +	/* TODO: setting to 4 MIPI lanes always for now */
>  	dsi->lanes = 4;
>  	dsi->format = MIPI_DSI_FMT_RGB888;
>  	dsi->mode_flags = MIPI_DSI_MODE_VIDEO;
> @@ -511,12 +510,41 @@ static void ti_sn_bridge_set_video_timings(struct ti_sn_bridge *pdata)
>  	usleep_range(10000, 10500); /* 10ms delay recommended by spec */
>  }
>  
> +static unsigned int ti_sn_get_max_lanes(struct ti_sn_bridge *pdata)
> +{
> +	u8 data;
> +	int ret;
> +
> +	ret = drm_dp_dpcd_readb(&pdata->aux, DP_MAX_LANE_COUNT, &data);
> +	if (ret != 1) {
> +		DRM_DEV_ERROR(pdata->dev,
> +			      "Can't read lane count (%d); assuming 4\n", ret);
> +		return 4;
> +	}
> +
> +	return data & DP_LANE_COUNT_MASK;
> +}
> +
>  static void ti_sn_bridge_enable(struct drm_bridge *bridge)
>  {
>  	struct ti_sn_bridge *pdata = bridge_to_ti_sn_bridge(bridge);
>  	unsigned int val;
>  	int ret;
>  
> +	/*
> +	 * Run with the maximum number of lanes that the DP sink supports.
> +	 *
> +	 * Depending use cases, we might want to revisit this later because:
> +	 * - It's plausible that someone may have run fewer lines to the
> +	 *   sink than the sink actually supports, assuming that the lines
> +	 *   will just be driven at a higher rate.
> +	 * - The DP spec seems to indicate that it's more important to minimize
> +	 *   the number of lanes than the link rate.
> +	 *
> +	 * If we do revisit, it would be important to measure the power impact.
> +	 */
> +	pdata->dp_lanes = ti_sn_get_max_lanes(pdata);
> +
>  	/* DSI_A lane config */
>  	val = CHA_DSI_LANES(4 - pdata->dsi->lanes);
>  	regmap_update_bits(pdata->regmap, SN_DSI_LANES_REG,
> -- 
> 2.24.1.735.g03f4e72817-goog
>