Re: [PATCH net-next v2] net: phy: dp83867: Add speed optimization feature

[Dan Murphy]

Heiner

On 2/4/20 2:08 PM, Heiner Kallweit wrote:
> On 04.02.2020 19:13, Dan Murphy wrote:
> > Set the speed optimization bit on the DP83867 PHY.
> > This feature can also be strapped on the 64 pin PHY devices
> > but the 48 pin devices do not have the strap pin available to enable
> > this feature in the hardware.  PHY team suggests to have this bit set.
> >
> > With this bit set the PHY will auto negotiate and report the link
> > parameters in the PHYSTS register.  This register provides a single
> > location within the register set for quick access to commonly accessed
> > information.
> >
> > In this case when auto negotiation is on the PHY core reads the bits
> > that have been configured or if auto negotiation is off the PHY core
> > reads the BMCR register and sets the phydev parameters accordingly.
> >
> > This Giga bit PHY can throttle the speed to 100Mbps or 10Mbps to accomodate a
> > 4-wire cable.  If this should occur the PHYSTS register contains the
> > current negotiated speed and duplex mode.
> >
> > In overriding the genphy_read_status the dp83867_read_status will do a
> > genphy_read_status to setup the LP and pause bits.  And then the PHYSTS
> > register is read and the phydev speed and duplex mode settings are
> > updated.
> >
> > Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
> net-next is closed currently. See here for details:
> https://www.kernel.org/doc/Documentation/networking/netdev-FAQ.txt
> Reopening will be announced on the netdev mailing list, you can also
> check net-next status here: http://vger.kernel.org/~davem/net-next.html
Thanks Heiner for the link I RTM. I will wait for the opening.

Dan