[PATCH 5.4 187/309] drm: atmel-hlcdc: enable clock before configuring timing engine

[Greg Kroah-Hartman]

From: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx>

commit 2c1fb9d86f6820abbfaa38a6836157c76ccb4e7b upstream.

Changing pixel clock source without having this clock source enabled
will block the timing engine and the next operations after (in this case
setting ATMEL_HLCDC_CFG(5) settings in atmel_hlcdc_crtc_mode_set_nofb()
will fail). It is recomended (although in datasheet this is not present)
to actually enabled pixel clock source before doing any changes on timing
enginge (only SAM9X60 datasheet specifies that the peripheral clock and
pixel clock must be enabled before using LCD controller).

Fixes: 1a396789f65a ("drm: add Atmel HLCDC Display Controller support")
Signed-off-by: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx>
Signed-off-by: Sam Ravnborg <sam@xxxxxxxxxxxx>
Cc: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
Cc: <stable@xxxxxxxxxxxxxxx> # v4.0+
Link: https://patchwork.freedesktop.org/patch/msgid/1576672109-22707-3-git-send-email-claudiu.beznea@xxxxxxxxxxxxx
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>

---
 drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c |    8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

--- a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
+++ b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
@@ -73,7 +73,11 @@ static void atmel_hlcdc_crtc_mode_set_no
 	unsigned long prate;
 	unsigned int mask = ATMEL_HLCDC_CLKDIV_MASK | ATMEL_HLCDC_CLKPOL;
 	unsigned int cfg = 0;
-	int div;
+	int div, ret;
+
+	ret = clk_prepare_enable(crtc->dc->hlcdc->sys_clk);
+	if (ret)
+		return;
 
 	vm.vfront_porch = adj->crtc_vsync_start - adj->crtc_vdisplay;
 	vm.vback_porch = adj->crtc_vtotal - adj->crtc_vsync_end;
@@ -147,6 +151,8 @@ static void atmel_hlcdc_crtc_mode_set_no
 			   ATMEL_HLCDC_VSPSU | ATMEL_HLCDC_VSPHO |
 			   ATMEL_HLCDC_GUARDTIME_MASK | ATMEL_HLCDC_MODE_MASK,
 			   cfg);
+
+	clk_disable_unprepare(crtc->dc->hlcdc->sys_clk);
 }
 
 static enum drm_mode_status