[PATCH 13/18] unicore32: replace setup_irq() by request_irq()

[afzal mohammed]

request_irq() is preferred over setup_irq(). Existing callers of
setup_irq() reached mostly via 'init_IRQ()' & 'time_init()', while
memory allocators are ready by 'mm_init()'.

Per tglx[1], setup_irq() existed in olden days when allocators were not
ready by the time early interrupts were initialized.

Hence replace setup_irq() by request_irq().

Seldom remove_irq() usage has been observed coupled with setup_irq(),
wherever that has been found, it too has been replaced by free_irq().

[1] https://lkml.kernel.org/r/alpine.DEB.2.20.1710191609480.1971@nanos

Signed-off-by: afzal mohammed <afzal.mohd.ma@xxxxxxxxx>
---

Since cc'ing cover letter to all maintainers/reviewers would be too
many, refer for cover letter,
 https://lkml.kernel.org/r/cover.1581478323.git.afzal.mohd.ma@xxxxxxxxx

 arch/unicore32/kernel/time.c | 11 +++--------
 1 file changed, 3 insertions(+), 8 deletions(-)

diff --git a/arch/unicore32/kernel/time.c b/arch/unicore32/kernel/time.c
index 8b217a761bf0..6f29c3ae95ff 100644
--- a/arch/unicore32/kernel/time.c
+++ b/arch/unicore32/kernel/time.c
@@ -72,13 +72,6 @@ static struct clocksource cksrc_puv3_oscr = {
 	.flags		= CLOCK_SOURCE_IS_CONTINUOUS,
 };
 
-static struct irqaction puv3_timer_irq = {
-	.name		= "ost0",
-	.flags		= IRQF_TIMER | IRQF_IRQPOLL,
-	.handler	= puv3_ost0_interrupt,
-	.dev_id		= &ckevt_puv3_osmr0,
-};
-
 void __init time_init(void)
 {
 	writel(0, OST_OIER);		/* disable any timer interrupts */
@@ -94,7 +87,9 @@ void __init time_init(void)
 	ckevt_puv3_osmr0.min_delta_ticks = MIN_OSCR_DELTA * 2;
 	ckevt_puv3_osmr0.cpumask = cpumask_of(0);
 
-	setup_irq(IRQ_TIMER0, &puv3_timer_irq);
+	if (request_irq(IRQ_TIMER0, puv3_ost0_interrupt,
+			IRQF_TIMER | IRQF_IRQPOLL, "ost0", &ckevt_puv3_osmr0))
+		pr_err("request_irq() on %s failed\n", "ost0");
 
 	clocksource_register_hz(&cksrc_puv3_oscr, CLOCK_TICK_RATE);
 	clockevents_register_device(&ckevt_puv3_osmr0);
-- 
2.24.1