[PATCH 1/2] media: dt-bindings: media: i2c: Switch to assigned-clock-rates

[Lad Prabhakar]

Use assigned-clock-rates to specify the clock rate.

Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/media/i2c/ov5645.txt | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/media/i2c/ov5645.txt b/Documentation/devicetree/bindings/media/i2c/ov5645.txt
index 72ad992..1c85c78 100644
--- a/Documentation/devicetree/bindings/media/i2c/ov5645.txt
+++ b/Documentation/devicetree/bindings/media/i2c/ov5645.txt
@@ -8,7 +8,6 @@ Required Properties:
 - compatible: Value should be "ovti,ov5645".
 - clocks: Reference to the xclk clock.
 - clock-names: Should be "xclk".
-- clock-frequency: Frequency of the xclk clock.
 - enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds
   to the hardware pin PWDNB which is physically active low.
 - reset-gpios: Chip reset GPIO. Polarity is GPIO_ACTIVE_LOW. This corresponds to
@@ -37,7 +36,8 @@ Example:
 
 			clocks = <&clks 200>;
 			clock-names = "xclk";
-			clock-frequency = <24000000>;
+			assigned-clocks = <&clks 200>;
+			assigned-clock-rates = <24000000>;
 
 			vdddo-supply = <&camera_dovdd_1v8>;
 			vdda-supply = <&camera_avdd_2v8>;
-- 
2.7.4