Re: [PATCH v2 0/9] brcmfmac: add support for BCM4359 SDIO chipset

From: Chi-Hsien Lin
Date: Fri Mar 13 2020 - 07:04:32 EST




On 12/16/2019 7:43, Heiko StÃbner wrote:
Hi Soeren,

Am Sonntag, 15. Dezember 2019, 22:24:10 CET schrieb Soeren Moch:
On 12.12.19 11:59, Soeren Moch wrote:
On 12.12.19 10:42, Kalle Valo wrote:
Soeren Moch <smoch@xxxxxx> writes:

Add support for the BCM4359 chipset with SDIO interface and RSDB support
to the brcmfmac wireless network driver in patches 1-7.

Enhance devicetree of the RockPro64 arm64/rockchip board to use an
AP6359SA based wifi/bt combo module with this chipset in patches 8-9.


Chung-Hsien Hsu (1):
brcmfmac: set F2 blocksize and watermark for 4359

Soeren Moch (5):
brcmfmac: fix rambase for 4359/9
brcmfmac: make errors when setting roaming parameters non-fatal
brcmfmac: add support for BCM4359 SDIO chipset
arm64: dts: rockchip: RockPro64: enable wifi module at sdio0
arm64: dts: rockchip: RockPro64: hook up bluetooth at uart0

Wright Feng (3):
brcmfmac: reset two D11 cores if chip has two D11 cores
brcmfmac: add RSDB condition when setting interface combinations
brcmfmac: not set mbss in vif if firmware does not support MBSS

.../boot/dts/rockchip/rk3399-rockpro64.dts | 50 +++++++++++---
.../broadcom/brcm80211/brcmfmac/bcmsdh.c | 8 ++-
.../broadcom/brcm80211/brcmfmac/cfg80211.c | 68 +++++++++++++++----
.../broadcom/brcm80211/brcmfmac/chip.c | 54 ++++++++++++++-
.../broadcom/brcm80211/brcmfmac/chip.h | 1 +
.../broadcom/brcm80211/brcmfmac/pcie.c | 2 +-
.../broadcom/brcm80211/brcmfmac/sdio.c | 17 +++++
include/linux/mmc/sdio_ids.h | 2 +
8 files changed, 176 insertions(+), 26 deletions(-)
Just to make sure we are on the same page, I will apply patches 1-7 to
wireless-drivers-next and patches 8-9 go to some other tree? And there
are no dependencies between the brcmfmac patches and dts patches?

Yes, this also is my understanding. I'm glad if you are fine with
patches 1-7.
Heiko will pick up patches 8-9 later for linux-rockchip independently.
And if we need another round of review for patches 8-9, I think we don't
need to bother linux-wireless with this.

Heiko,

is this OK for you when patches 1-7 are merged now in wireless-drivers,
and then I send a v3 for patches 8-9 only for you to merge in
linux-rockchip later? Or do you prefer a full v3 for the whole series
with only this pending clock name update in patch 9?

Nope, merging 1-7 from this v2 and then getting a v3 with only the dts
stuff is perfectly fine :-)

Soeren,

I suppose patch 1-7 from this serious are all good for merging. Is that right? If so, could you please create a rebased V3?


Regards,
Chi-hsien Lin


Heiko


.