Re: [PATCH v3 1/4] media: dt-bindings: media: i2c: Switch to assigned-clock-rates

[Lad, Prabhakar]

Hi Laurent,

On Fri, Mar 13, 2020 at 9:27 PM Laurent Pinchart
<laurent.pinchart@xxxxxxxxxxxxxxxx> wrote:
>
> Hi Prabhakar,
>
> On Fri, Mar 13, 2020 at 09:25:01PM +0000, Prabhakar Mahadev Lad wrote:
> > On Sent: 13 March 2020 21:20, Laurent Pinchart wrote:
> > > On Fri, Mar 13, 2020 at 09:12:31PM +0000, Lad Prabhakar wrote:
> > > > Use assigned-clock-rates to specify the clock rate. Also mark
> > > > clock-frequency property as deprecated.
> > >
> > > I would phrase it the other way around, this patch mainly deprecates clock-
> > > frequency, and as a side effect recommends usage of assigned-clock-rates.
> > >
> > > "Deprecate usage of the clock-frequency propertly. The preferred method
> > > to set clock rates is to use assigned-clock-rates."
> >
> > Agreed will do that.
> >
> > > > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
> > > > ---
> > > >  Documentation/devicetree/bindings/media/i2c/ov5645.txt | 5 +++--
> > > >  1 file changed, 3 insertions(+), 2 deletions(-)
> > > >
> > > > diff --git a/Documentation/devicetree/bindings/media/i2c/ov5645.txt
> > > > b/Documentation/devicetree/bindings/media/i2c/ov5645.txt
> > > > index 72ad992..e62fe82 100644
> > > > --- a/Documentation/devicetree/bindings/media/i2c/ov5645.txt
> > > > +++ b/Documentation/devicetree/bindings/media/i2c/ov5645.txt
> > > > @@ -8,7 +8,7 @@ Required Properties:
> > > >  - compatible: Value should be "ovti,ov5645".
> > > >  - clocks: Reference to the xclk clock.
> > > >  - clock-names: Should be "xclk".
> > > > -- clock-frequency: Frequency of the xclk clock.
> > > > +- clock-frequency (deprecated): Frequency of the xclk clock.
> > >
> > > I would drop this completely. Drivers need to ensure backward compatibility,
> > > but DT bindings should only document the latest version, the history is
> > > available in git.
> > >
> > Sure will drop it.
> >
> > > Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
> > >
> > > While at it, can I enlist you to convert these bindings to yaml ? :-)
> > >
> > Sure will do the honours , will make sure yaml patch is ontop of this patch too.
>
Shall I enlist you as the maintainer  in the json-schema ?
dt_binding_check says  'maintainers' is a required property.

Cheers,
--Prabhakar Lad

> Thank you :-)
>
> > > >  - enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds
> > > >    to the hardware pin PWDNB which is physically active low.
> > > >  - reset-gpios: Chip reset GPIO. Polarity is GPIO_ACTIVE_LOW. This corresponds to
> > > > @@ -37,7 +37,8 @@ Example:
> > > >
> > > >  clocks = <&clks 200>;
> > > >  clock-names = "xclk";
> > > > -clock-frequency = <24000000>;
> > > > +assigned-clocks = <&clks 200>;
> > > > +assigned-clock-rates = <24000000>;
> > > >
> > > >  vdddo-supply = <&camera_dovdd_1v8>;
> > > >  vdda-supply = <&camera_avdd_2v8>;
>
> --
> Regards,
>
> Laurent Pinchart
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel