Re: [PATCH v7] iio: adc: max1363: replace uses of mlock

[Rohit Sarkar]

Hey,
Does this look fine? Wondering if this was missed during review
Thanks,
Rohit

On Sun, Mar 15, 2020 at 09:34:58PM +0530, Rohit Sarkar wrote:
> Replace usage indio_dev's mlock with either local lock or
> iio_device_claim_direct_mode.
> 
> Signed-off-by: Rohit Sarkar <rohitsarkar5398@xxxxxxxxx>
> ---
> Changelog v6 -> v7
> * Fix failure handling logic
> 
> Changelog v5 -> v6
> * Minor failure handling fixes
> 
> Changelog v4 -> v5
> * Use local lock too at places where driver state needs to be protected.
> 
> Changelog v3 -> v4
> * Fix indentation
> 
> Changelog v2 -> v3
> * use iio_device_claim_direct when switching modes
> * replace mlock usage in max1363_write_event_config
> 
> Changelog v1 -> v2
> * Fix indentation
> 
>  drivers/iio/adc/max1363.c | 37 ++++++++++++++++++++++++++++---------
>  1 file changed, 28 insertions(+), 9 deletions(-)
> 
> diff --git a/drivers/iio/adc/max1363.c b/drivers/iio/adc/max1363.c
> index 5c2cc61b666e..12d72bf3f12a 100644
> --- a/drivers/iio/adc/max1363.c
> +++ b/drivers/iio/adc/max1363.c
> @@ -150,6 +150,7 @@ struct max1363_chip_info {
>   * @current_mode:	the scan mode of this chip
>   * @requestedmask:	a valid requested set of channels
>   * @reg:		supply regulator
> + * @lock		lock to ensure state is consistent
>   * @monitor_on:		whether monitor mode is enabled
>   * @monitor_speed:	parameter corresponding to device monitor speed setting
>   * @mask_high:		bitmask for enabled high thresholds
> @@ -169,6 +170,7 @@ struct max1363_state {
>  	const struct max1363_mode	*current_mode;
>  	u32				requestedmask;
>  	struct regulator		*reg;
> +	struct mutex			lock;
>  
>  	/* Using monitor modes and buffer at the same time is
>  	   currently not supported */
> @@ -364,7 +366,13 @@ static int max1363_read_single_chan(struct iio_dev *indio_dev,
>  	struct max1363_state *st = iio_priv(indio_dev);
>  	struct i2c_client *client = st->client;
>  
> -	mutex_lock(&indio_dev->mlock);
> +	ret = iio_device_claim_direct_mode(indio_dev);
> +	if (ret)
> +		return ret;
> +	mutex_lock(&st->lock);
> +
> +	if (ret < 0)
> +		goto error_ret;
>  	/*
>  	 * If monitor mode is enabled, the method for reading a single
>  	 * channel will have to be rather different and has not yet
> @@ -372,7 +380,7 @@ static int max1363_read_single_chan(struct iio_dev *indio_dev,
>  	 *
>  	 * Also, cannot read directly if buffered capture enabled.
>  	 */
> -	if (st->monitor_on || iio_buffer_enabled(indio_dev)) {
> +	if (st->monitor_on) {
>  		ret = -EBUSY;
>  		goto error_ret;
>  	}
> @@ -404,8 +412,10 @@ static int max1363_read_single_chan(struct iio_dev *indio_dev,
>  		data = rxbuf[0];
>  	}
>  	*val = data;
> +
>  error_ret:
> -	mutex_unlock(&indio_dev->mlock);
> +	mutex_unlock(&st->lock);
> +	iio_device_release_direct_mode(indio_dev);
>  	return ret;
>  
>  }
> @@ -705,9 +715,9 @@ static ssize_t max1363_monitor_store_freq(struct device *dev,
>  	if (!found)
>  		return -EINVAL;
>  
> -	mutex_lock(&indio_dev->mlock);
> +	mutex_lock(&st->lock);
>  	st->monitor_speed = i;
> -	mutex_unlock(&indio_dev->mlock);
> +	mutex_unlock(&st->lock);
>  
>  	return 0;
>  }
> @@ -810,12 +820,12 @@ static int max1363_read_event_config(struct iio_dev *indio_dev,
>  	int val;
>  	int number = chan->channel;
>  
> -	mutex_lock(&indio_dev->mlock);
> +	mutex_lock(&st->lock);
>  	if (dir == IIO_EV_DIR_FALLING)
>  		val = (1 << number) & st->mask_low;
>  	else
>  		val = (1 << number) & st->mask_high;
> -	mutex_unlock(&indio_dev->mlock);
> +	mutex_unlock(&st->lock);
>  
>  	return val;
>  }
> @@ -962,7 +972,14 @@ static int max1363_write_event_config(struct iio_dev *indio_dev,
>  	u16 unifiedmask;
>  	int number = chan->channel;
>  
> -	mutex_lock(&indio_dev->mlock);
> +	ret = iio_device_claim_direct_mode(indio_dev);
> +	if (ret)
> +		return ret;
> +	mutex_lock(&st->lock);
> +
> +	if (ret < 0)
> +		goto error_ret;
> +
>  	unifiedmask = st->mask_low | st->mask_high;
>  	if (dir == IIO_EV_DIR_FALLING) {
>  
> @@ -989,7 +1006,8 @@ static int max1363_write_event_config(struct iio_dev *indio_dev,
>  
>  	max1363_monitor_mode_update(st, !!(st->mask_high | st->mask_low));
>  error_ret:
> -	mutex_unlock(&indio_dev->mlock);
> +	mutex_unlock(&st->lock);
> +	iio_device_release_direct_mode(indio_dev);
>  
>  	return ret;
>  }
> @@ -1587,6 +1605,7 @@ static int max1363_probe(struct i2c_client *client,
>  
>  	st = iio_priv(indio_dev);
>  
> +	mutex_init(&st->lock);
>  	st->reg = devm_regulator_get(&client->dev, "vcc");
>  	if (IS_ERR(st->reg)) {
>  		ret = PTR_ERR(st->reg);
> -- 
> 2.23.0.385.gbc12974a89
>