Re: [PATCH v4 3/3] dt-bindings: thermal: Add yaml bindings for thermal zones

[Lukasz Luba]

Hi Amit,

Apart from small mistake during probably copy-paste (please check
below), looks good.

On 4/1/20 12:15 PM, Amit Kucheria wrote:
> As part of moving the thermal bindings to YAML, split it up into 3
> bindings: thermal sensors, cooling devices and thermal zones.
>
> The thermal-zone binding is a software abstraction to capture the
> properties of each zone - how often they should be checked, the
> temperature thresholds (trips) at which mitigation actions need to be
> taken and the level of mitigation needed at those thresholds.
>
> Signed-off-by: Amit Kucheria <amit.kucheria@xxxxxxxxxx>
> Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> ---
> Changes since v3:
>   - Clarify example by using cooling state numbers and a comment
>   - Restrict thermal-sensors to a single reference to reflect actual code
>     where there is a one-to-one mapping between sensors and thermal zones
>   - Add two optional properties that were missed in earlier submissions:
>     coefficients and sustainable-power
>   - Improve description of hysteresis and contribution properties
>
>   .../bindings/thermal/thermal-zones.yaml       | 341 ++++++++++++++++++
>   1 file changed, 341 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/thermal/thermal-zones.yaml

[snip]

> +                    cooling-maps {
> +                            map0 {
> +                                    trip = <&cpu0_alert0>;
> +                                    /* Corresponds to 1400MHz in OPP table */
> +                                    cooling-device = <&CPU0 3 3>, <&CPU1 3 3>,
> +                                                     <&CPU2 3 3>, <&CPU3 3 3>;
> +                            };
> +
> +                            map1 {
> +                                    trip = <&cpu0_alert1>;
> +                                    /* Corresponds to 1400MHz in OPP table */

s/1400MHz/1000MHz/
1400MHZ is used in map0 as <&CPUx 3 3>, here we have '5 5'.


> +                                    cooling-device = <&CPU0 5 5>, <&CPU1 5 5>,
> +                                                     <&CPU2 5 5>, <&CPU3 5 5>;
> +                            };
> +                    };
> +            };


Apart from that, looks good:

Reviewed-by: Lukasz Luba <lukasz.luba@xxxxxxx>

Regards,
Lukasz