[PATCH 5.5 29/30] arm64: dts: ls1043a-rdb: correct RGMII delay mode to rgmii-id

[Greg Kroah-Hartman]

From: Madalin Bucur <madalin.bucur@xxxxxxxxxxx>

commit 4022d808c45277693ea86478fab1f081ebf997e8 upstream.

The correct setting for the RGMII ports on LS1043ARDB is to
enable delay on both Rx and Tx so the interface mode used must
be PHY_INTERFACE_MODE_RGMII_ID.

Since commit 1b3047b5208a80 ("net: phy: realtek: add support for
configuring the RX delay on RTL8211F") the Realtek 8211F PHY driver
has control over the RGMII RX delay and it is disabling it for
RGMII_TXID. The LS1043ARDB uses two such PHYs in RGMII_ID mode but
in the device tree the mode was described as "rgmii_txid".
This issue was not apparent at the time as the PHY driver took the
same action for RGMII_TXID and RGMII_ID back then but it became
visible (RX no longer working) after the above patch.

Changing the phy-connection-type to "rgmii-id" to address the issue.

Fixes: bf02f2ffe59c ("arm64: dts: add LS1043A DPAA FMan support")
Signed-off-by: Madalin Bucur <madalin.bucur@xxxxxxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>

---
 arch/arm64/boot/dts/freescale/fsl-ls1043a-rdb.dts |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

--- a/arch/arm64/boot/dts/freescale/fsl-ls1043a-rdb.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1043a-rdb.dts
@@ -119,12 +119,12 @@
 
 	ethernet@e4000 {
 		phy-handle = <&rgmii_phy1>;
-		phy-connection-type = "rgmii-txid";
+		phy-connection-type = "rgmii-id";
 	};
 
 	ethernet@e6000 {
 		phy-handle = <&rgmii_phy2>;
-		phy-connection-type = "rgmii-txid";
+		phy-connection-type = "rgmii-id";
 	};
 
 	ethernet@e8000 {