[PATCH 4.14 068/148] net: dsa: mt7530: Change the LINK bit to reflect the link status

[Greg Kroah-Hartman]

From: "Renéan Dorst" <opensource@xxxxxxxxxx>

[ Upstream commit 22259471b51925353bd7b16f864c79fdd76e425e ]

Andrew reported:

After a number of network port link up/down changes, sometimes the switch
port gets stuck in a state where it thinks it is still transmitting packets
but the cpu port is not actually transmitting anymore. In this state you
will see a message on the console
"mtk_soc_eth 1e100000.ethernet eth0: transmit timed out" and the Tx counter
in ifconfig will be incrementing on virtual port, but not incrementing on
cpu port.

The issue is that MAC TX/RX status has no impact on the link status or
queue manager of the switch. So the queue manager just queues up packets
of a disabled port and sends out pause frames when the queue is full.

Change the LINK bit to reflect the link status.

Fixes: b8f126a8d543 ("net-next: dsa: add dsa support for Mediatek MT7530 switch")
Reported-by: Andrew Smith <andrew.smith@xxxxxxxx>
Signed-off-by: Renà van Dorst <opensource@xxxxxxxxxx>
Reviewed-by: Vivien Didelot <vivien.didelot@xxxxxxxxx>
Reviewed-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/net/dsa/mt7530.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -549,7 +549,7 @@ mt7530_mib_reset(struct dsa_switch *ds)
 static void
 mt7530_port_set_status(struct mt7530_priv *priv, int port, int enable)
 {
-	u32 mask = PMCR_TX_EN | PMCR_RX_EN;
+	u32 mask = PMCR_TX_EN | PMCR_RX_EN | PMCR_FORCE_LNK;
 
 	if (enable)
 		mt7530_set(priv, MT7530_PMCR_P(port), mask);