Re: [PATCH 2/3] iio: chemical: Add support for external Reset and Wakeup in CCS811

[Andy Shevchenko]

On Mon, Apr 13, 2020 at 8:34 AM <mani@xxxxxxxxxx> wrote:
>
> From: Manivannan Sadhasivam <mani@xxxxxxxxxx>
>
> CCS811 VOC sensor exposes nRESET and nWAKE pins which can be connected
> to GPIO pins of the host controller. These pins can be used to externally
> release the device from reset and also to wake it up before any I2C
> transaction. The initial driver support assumed that the nRESET pin is not
> connected and the nWAKE pin is tied to ground.
>
> This commit improves it by adding support for controlling those two pins
> externally using a host controller. For the case of reset, if the hardware
> reset is not available, the mechanism to do software reset is also added.
>
> As a side effect of doing this, the IIO device allocation needs to be
> slightly moved to top of probe to make use of priv data early.

...

> +#define CCS811_SW_RESET                0xFF


> +       reset_gpio = devm_gpiod_get_optional(&client->dev, "reset",
> +                                            GPIOD_OUT_LOW);
> +       if (IS_ERR(reset_gpio)) {
> +               dev_err(&client->dev, "Failed to acquire reset gpio\n");

> +               return -EINVAL;

Do not shadow actual error code.

> +       }
> +
> +       /* Try to reset using nRESET pin if available else do SW reset */
> +       if (reset_gpio) {
> +               gpiod_set_value(reset_gpio, 1);
> +               usleep_range(20, 30);
> +               gpiod_set_value(reset_gpio, 0);
> +       } else {

> +               static const u8 reset_seq[] = {
> +                       0xFF, 0x11, 0xE5, 0x72, 0x8A,
> +               };

Is 0xFF here is CCS811_SW_RESET? If so, can you put it explicitly?

> +               ret = i2c_smbus_write_i2c_block_data(client, CCS811_SW_RESET,
> +                                            sizeof(reset_seq), reset_seq);
> +               if (ret < 0) {
> +                       dev_err(&client->dev, "Failed to reset sensor\n");
> +                       return ret;
> +               }
> +       }

...

> +       data->wakeup_gpio = devm_gpiod_get_optional(&client->dev, "wakeup",
> +                                                   GPIOD_OUT_HIGH);
> +       if (IS_ERR(data->wakeup_gpio)) {
> +               dev_err(&client->dev, "Failed to acquire wakeup gpio\n");

> +               return -EINVAL;

Ditto.

> +       }

-- 
With Best Regards,
Andy Shevchenko