[PATCH 5.6 13/71] net: ethernet: mediatek: move mt7623 settings out off the mt7530

[Greg Kroah-Hartman]

From: "Renéan Dorst" <opensource@xxxxxxxxxx>

[ Upstream commit a5d75538295b06bc6ade1b9da07b9bee57d1c677 ]

Moving mt7623 logic out off mt7530, is required to make hardware setting
consistent after we introduce phylink to mtk driver.

Fixes: b8fc9f30821e ("net: ethernet: mediatek: Add basic PHYLINK support")
Reviewed-by: Sean Wang <sean.wang@xxxxxxxxxxxx>
Tested-by: Sean Wang <sean.wang@xxxxxxxxxxxx>
Signed-off-by: Renà van Dorst <opensource@xxxxxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/net/ethernet/mediatek/mtk_eth_soc.c |   24 +++++++++++++++++++++++-
 drivers/net/ethernet/mediatek/mtk_eth_soc.h |    8 ++++++++
 2 files changed, 31 insertions(+), 1 deletion(-)

--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -65,6 +65,17 @@ u32 mtk_r32(struct mtk_eth *eth, unsigne
 	return __raw_readl(eth->base + reg);
 }
 
+u32 mtk_m32(struct mtk_eth *eth, u32 mask, u32 set, unsigned reg)
+{
+	u32 val;
+
+	val = mtk_r32(eth, reg);
+	val &= ~mask;
+	val |= set;
+	mtk_w32(eth, val, reg);
+	return reg;
+}
+
 static int mtk_mdio_busy_wait(struct mtk_eth *eth)
 {
 	unsigned long t_start = jiffies;
@@ -193,7 +204,7 @@ static void mtk_mac_config(struct phylin
 	struct mtk_mac *mac = container_of(config, struct mtk_mac,
 					   phylink_config);
 	struct mtk_eth *eth = mac->hw;
-	u32 mcr_cur, mcr_new, sid;
+	u32 mcr_cur, mcr_new, sid, i;
 	int val, ge_mode, err;
 
 	/* MT76x8 has no hardware settings between for the MAC */
@@ -255,6 +266,17 @@ static void mtk_mac_config(struct phylin
 				    PHY_INTERFACE_MODE_TRGMII)
 					mtk_gmac0_rgmii_adjust(mac->hw,
 							       state->speed);
+
+				/* mt7623_pad_clk_setup */
+				for (i = 0 ; i < NUM_TRGMII_CTRL; i++)
+					mtk_w32(mac->hw,
+						TD_DM_DRVP(8) | TD_DM_DRVN(8),
+						TRGMII_TD_ODT(i));
+
+				/* Assert/release MT7623 RXC reset */
+				mtk_m32(mac->hw, 0, RXC_RST | RXC_DQSISEL,
+					TRGMII_RCK_CTRL);
+				mtk_m32(mac->hw, RXC_RST, 0, TRGMII_RCK_CTRL);
 			}
 		}
 
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.h
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.h
@@ -352,10 +352,13 @@
 #define DQSI0(x)		((x << 0) & GENMASK(6, 0))
 #define DQSI1(x)		((x << 8) & GENMASK(14, 8))
 #define RXCTL_DMWTLAT(x)	((x << 16) & GENMASK(18, 16))
+#define RXC_RST			BIT(31)
 #define RXC_DQSISEL		BIT(30)
 #define RCK_CTRL_RGMII_1000	(RXC_DQSISEL | RXCTL_DMWTLAT(2) | DQSI1(16))
 #define RCK_CTRL_RGMII_10_100	RXCTL_DMWTLAT(2)
 
+#define NUM_TRGMII_CTRL		5
+
 /* TRGMII RXC control register */
 #define TRGMII_TCK_CTRL		0x10340
 #define TXCTL_DMWTLAT(x)	((x << 16) & GENMASK(18, 16))
@@ -363,6 +366,11 @@
 #define TCK_CTRL_RGMII_1000	TXCTL_DMWTLAT(2)
 #define TCK_CTRL_RGMII_10_100	(TXC_INV | TXCTL_DMWTLAT(2))
 
+/* TRGMII TX Drive Strength */
+#define TRGMII_TD_ODT(i)	(0x10354 + 8 * (i))
+#define  TD_DM_DRVP(x)		((x) & 0xf)
+#define  TD_DM_DRVN(x)		(((x) & 0xf) << 4)
+
 /* TRGMII Interface mode register */
 #define INTF_MODE		0x10390
 #define TRGMII_INTF_DIS		BIT(0)