Re: [PATCH] ACPI: PM: Output correct message on target power state
From: Rafael J. Wysocki
Date: Sun Apr 26 2020 - 12:37:05 EST
On Tuesday, April 21, 2020 9:55:16 AM CEST Kai-Heng Feng wrote:
> Transitioned power state logged at the end of setting ACPI power.
>
> However, D3cold won't be in the message because state can only be D3hot
> at most.
>
> Use target_state to corretly report when power state is D3cold.
>
> Signed-off-by: Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx>
> ---
> drivers/acpi/device_pm.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/acpi/device_pm.c b/drivers/acpi/device_pm.c
> index b2263ec67b43..5832bc10aca8 100644
> --- a/drivers/acpi/device_pm.c
> +++ b/drivers/acpi/device_pm.c
> @@ -273,13 +273,13 @@ int acpi_device_set_power(struct acpi_device *device, int state)
> end:
> if (result) {
> dev_warn(&device->dev, "Failed to change power state to %s\n",
> - acpi_power_state_string(state));
> + acpi_power_state_string(target_state));
> } else {
> device->power.state = target_state;
> ACPI_DEBUG_PRINT((ACPI_DB_INFO,
> "Device [%s] transitioned to %s\n",
> device->pnp.bus_id,
> - acpi_power_state_string(state)));
> + acpi_power_state_string(target_state)));
> }
>
> return result;
>
Applied as a fix for 5.7-rc4, thanks!