[PATCH v3 4/5] tools/testing/selftests/sysctl/sysctl.sh: support CONFIG_TEST_SYSCTL=y

[Vlastimil Babka]

The testing script recommends CONFIG_TEST_SYSCTL=y, but actually only works
with CONFIG_TEST_SYSCTL=m. Testing of sysctl setting via boot param however
requires the test to be built-in, so make sure the test script supports it.

Signed-off-by: Vlastimil Babka <vbabka@xxxxxxx>
---
 tools/testing/selftests/sysctl/sysctl.sh | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/tools/testing/selftests/sysctl/sysctl.sh b/tools/testing/selftests/sysctl/sysctl.sh
index 6a970b127c9b..ce1eeea6f769 100755
--- a/tools/testing/selftests/sysctl/sysctl.sh
+++ b/tools/testing/selftests/sysctl/sysctl.sh
@@ -42,7 +42,7 @@ ALL_TESTS="$ALL_TESTS 0006:50:1:bitmap_0001"
 
 test_modprobe()
 {
-       if [ ! -d $DIR ]; then
+       if [ ! -d $SYSCTL ]; then
                echo "$0: $DIR not present" >&2
                echo "You must have the following enabled in your kernel:" >&2
                cat $TEST_DIR/config >&2
@@ -122,9 +122,9 @@ test_reqs()
 
 function load_req_mod()
 {
-	if [ ! -d $DIR ]; then
+	if [ ! -d $DIR -a ! -d $SYSCTL ]; then
 		if ! modprobe -q -n $TEST_DRIVER; then
-			echo "$0: module $TEST_DRIVER not found [SKIP]"
+			echo "$0: module $TEST_DRIVER not found and not built-in [SKIP]"
 			exit $ksft_skip
 		fi
 		modprobe $TEST_DRIVER
-- 
2.26.0