Re: [External] Re: [PATCH v5 5/8] usb: mausb_host: Introduce PAL processing

[Alan Stern]

On Thu, 30 Apr 2020, Vladimir Stankovic wrote:

> On 30.4.20. 17:18, Alan Stern wrote:
> > On Thu, 30 Apr 2020, Vladimir Stankovic wrote:
> > 
> >> On 26.4.20. 22:56, Alan Stern wrote:
> >>> On Sun, 26 Apr 2020, Vladimir Stankovic wrote:
> >>>
> >>>> On 26.4.20. 16:31, Alan Stern wrote:
> >>>>> On Sun, 26 Apr 2020, Vladimir Stankovic wrote:
> >>>>>
> >>>>>> On 26.4.20. 02:32, Alan Stern wrote:
> >>>>>>> On Sat, 25 Apr 2020 vladimir.stankovic@xxxxxxxxxxxxxxx wrote:
> >>>>>>>
> >>>>>>>> Protocol adaptation layer (PAL) implementation has been added to
> >>>>>>>> introduce MA-USB structures and logic.
> >>>>>>>>
> >>>>>>>> Signed-off-by: Vladimir Stankovic <vladimir.stankovic@xxxxxxxxxxxxxxx>
> >>>>>>>
> >>>>>>> ...
> >>>>>>>
> >>>>>>>> +	/*
> >>>>>>>> +	 * Masking URB_SHORT_NOT_OK flag as SCSI driver is adding it where it
> >>>>>>>> +	 * should not, so it is breaking the USB drive on the linux
> >>>>>>>> +	 */
> >>>>>>>> +	urb->transfer_flags &= ~URB_SHORT_NOT_OK;
> > 
> > ...

> > Also, what makes you think the driver is setting the SHORT_NOT_OK flag
> > at the wrong time?  In fact, how can there be a wrong time?  
> > SHORT_NOT_OK is a valid flag to use with any control or bulk URB.
> > 
> > Alan Stern
> > 
> The comment is clearly wrong - as mentioned earlier, this fix was added in early
> development phase and I guess that implementer was not clear on how the particular
> flag was added. Investigation is ongoing around proper fix for this.
> 
> Anyhow, it is a usb-storage driver related to this - here is usb-related log snippet:
> 
> usb 3-1.1.2: new high-speed USB device number 5 using mausb_host_hcd_dev
> usb 3-1.1.2: New USB device found, idVendor=0951, idProduct=1666
> usb 3-1.1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
> usb 3-1.1.2: Product: DataTraveler 3.0
> usb 3-1.1.2: Manufacturer: Kingston
> usb 3-1.1.2: SerialNumber: 0C9D9210E304E311095E087A
> usb-storage 3-1.1.2:1.0: USB Mass Storage device detected
> scsi host3: usb-storage 3-1.1.2:1.0
> scsi 3:0:0:0: Direct-Access     Kingston DataTraveler 3.0 PMAP PQ: 0 ANSI: 6
> Attached scsi generic sg2 type 0
> [sdb] 30277632 512-byte logical blocks: (15.5 GB/14.4 GiB)
> 
> As can be seen, USB flash attached to remote device is properly enumerated via
> MA USB. Without the fix, usb driver is not able to read USB descriptors, ending
> up in USB storage not being accessible.

That's strange, considering that the SHORT_NOT_OK flag doesn't get set 
when the system is reading the device's USB descriptors.

Alan Stern