Re: [RFC PATCH v2 0/3] Prefer working VT console over SPCR and device-tree chosen stdout-path

[Alper Nebi Yasak]

On 01/05/2020 16:16, Andy Shevchenko wrote:
> On Fri, May 1, 2020 at 2:11 PM Alper Nebi Yasak
> <alpernebiyasak@xxxxxxxxx> wrote:
>> I'm assuming "by default" here means "without console arguments"
>> regardless of firmware requests. This paragraph (with small changes) is
>> repeated on many other Kconfig descriptions (drivers/tty/serial/Kconfig,
>> drivers/tty/serial/8250/Kconfig, arch/sparc/Kconfig from grepping for
>> '/dev/tty0' on **/Kconfig).
>>
>>  From Documentation/admin-guide/serial-console.rst:
>>
>>> You can specify multiple console= options on the kernel command line.
>>> [...]
>>> Note that you can only define one console per device type (serial, video).
>>>
>>> If no console device is specified, the first device found capable of
>>> acting as a system console will be used. At this time, the system
>>> first looks for a VGA card and then for a serial port. So if you don't
>>> have a VGA card in your system the first serial port will automatically
>>> become the console.
>>
>> and later on:
>>
>>> Note that if you boot without a ``console=`` option (or with
>>> ``console=/dev/tty0``), ``/dev/console`` is the same as ``/dev/tty0``.
>>> In that case everything will still work.
> 
> I'm wondering if behaviour is changed if you put console=tty1 instead
> of console=tty0.

Just tested again with the QEMU aarch64 VM. Comparing console=tty1 and
console=tty0 cases: /proc/consoles has tty1 instead of tty0 (both also
has ttyAMA0), and `echo '/dev/console is here' >>/dev/console` goes to
vt1 instead of the currently visible vt. Same difference before and
after this patchset.