Re: [PATCH] ARM: dts: omap3: Migrate AES from hwmods to sysc-omap2

[Adam Ford]

On Tue, May 5, 2020 at 1:42 PM Tony Lindgren <tony@xxxxxxxxxxx> wrote:
>
> * Adam Ford <aford173@xxxxxxxxx> [200504 16:02]:
> > Various OMAP3 boards have two AES blocks, but only one is currently
> > available, because the hwmods are only configured for one.
> >
> > This patch migrates the hwmods for the AES engine to sysc-omap2
> > which allows the second AES crypto engine to become available.
> >
> >   omap-aes 480a6000.aes1: OMAP AES hw accel rev: 2.6
> >   omap-aes 480a6000.aes1: will run requests pump with realtime priority
> >   omap-aes 480c5000.aes2: OMAP AES hw accel rev: 2.6
> >   omap-aes 480c5000.aes2: will run requests pump with realtime priority
>
> Great :) Looks like I'm getting the following though:
>
> DTC     arch/arm/boot/dts/am3517-craneboard.dtb
> arch/arm/boot/dts/omap3.dtsi:160.39-184.5: ERROR (phandle_references):
> /ocp@68000000/target-module@480a6000:
> Reference to non-existent node or label "aes1_ick"
>
> Is this patch maybe missing a change for am3717 for the aes1_ick?

I am guessing it's the same issue that plagues the am3517 with a note
in the hwmods that stated noone seems to know which am3517's support
it and which don't.  The RNG was disabled on the 3517, so I am
guessing I'll do the same for AES.
I should have posted it as an RFC, because I don't have the proper IRQ
setup for the newly supported AES engine.  The interrupts that are
used for the original AES are listed as 'Resereved' in the AM3517 TRM.
I assume the second engine uses different interrupts.  I don't suppose
anyone know what it should be?

adam
>
> Regards,
>
> Tony