Re: [PATCH v5 2/2] mtd: rawnand: Add NAND controller support on Intel LGM SoC

[Ramuthevar, Vadivel MuruganX]

Hi Boris,

   Thank you very much for the review comments and your time...

On 7/5/2020 1:28 pm, Boris Brezillon wrote:
> On Thu,  7 May 2020 08:15:37 +0800
> "Ramuthevar,Vadivel MuruganX"
> <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx> wrote:
>
> > +	reg = readl(ebu_host->ebu + EBU_ADDR_SEL(ebu_host->cs_num));
> > +	writel(reg | EBU_ADDR_MASK(5) | EBU_ADDR_SEL_REGEN,
> > +	       ebu_host->ebu + EBU_ADDR_SEL(ebu_host->cs_num));
>
> Seriously, did you really think I would not notice what you're doing
> here?
Yes , I know that you have very good understanding about this.
 You're reading the previous value which either contains a default
> mapping or has the mapping set by the bootloader, and write it back to
> the register along with a new mask and the REGEN bit set (which
> BTW is wrong since you don't mask out other fields before updating
> them).
There is no other field get overwritten
 This confirms that this Core -> FPI address translation exists
> and has to be set properly, so please stop lying about that.

Sorry, there is no SW translation, as I have mentioned that it's 
optional only, for safer side , reading and writing the default values.
The memory region to enabled that's my concern so written the same 
register values.

This will not be impact other fields, so please see below for reference

The EBU Address Select Registers EBU_ADDR_SEL_0 to EBU_ADDSEL3 establish 
and control memory regions for external accesses.

Reset Value: 17400001H


Regards
Vadivel

>