Re: MSI interrupt for xhci still lost on 5.6-rc6 after cpu hotplug

[Raj, Ashok]

 Hi Thomas,

I think i got mixed up with logical apic id and logical cpu :-(

Patch and trace attached.




On Thu, May 07, 2020 at 02:53:41PM +0200, Thomas Gleixner wrote:
> Ashok,
> 
> "Raj, Ashok" <ashok.raj@xxxxxxxxx> writes:
> 
> > We did a bit more tracing and it looks like the IRR check is actually
> > not happening on the right cpu. See below.
> 
> What?
> 
> >> So we have 3 points where an interrupt can fire:
> >> 
> >>  A) Before #2
> >> 
> >>  B) After #2 and before #3
> >> 
> >>  C) After #3
> >> 
> >> #A is hitting the old vector which is still valid on the old CPU and
> >>    will be handled once interrupts are enabled with the correct irq
> >>    descriptor - Normal operation (same as with maskable MSI)
> >> 
> >> #B This must be checked in the IRR because the there is no valid vector
> >>    on the old CPU.
> >
> > The check for IRR seems like on a random cpu3 vs checking for the new vector 33
> > on old cpu 6?
> 
> The whole sequence runs on CPU 3. If old CPU was 6 then this should
> never run on CPU 3.
> 
> > This is the place when we force the retrigger without the IRR check things seem to fix itself.
> 
> It's not fixing it. It's papering over the root cause.
> 
> > Did we miss something? 
> 
> Yes, you missed to analyze why this runs on CPU3 when old CPU is 6. But
> the last interrupt actually was on CPU3.
> 
> >     <idle>-0     [003] d.h.   200.278052: xhci_irq: xhci irq
> 
> Can you please provide the full trace and the patch you used to generate
> it?
> 

Cheers,
Ashok