Re: [PATCH v3 09/11] PCI: qcom: add ipq8064 rev2 variant and set tx term offset

[Rob Herring]

On Fri, May 01, 2020 at 12:06:16AM +0200, Ansuel Smith wrote:
> From: Sham Muthayyan <smuthayy@xxxxxxxxxxxxxx>
> 
> Add tx term offset support to pcie qcom driver need in some revision of
> the ipq806x SoC.
> Ipq8064 have tx term offset set to 7.
> Ipq8064-v2 revision and ipq8065 have the tx term offset set to 0.
> 
> Signed-off-by: Sham Muthayyan <smuthayy@xxxxxxxxxxxxxx>
> Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
> ---
>  drivers/pci/controller/dwc/pcie-qcom.c | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index da8058fd1925..372d2c8508b5 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -45,6 +45,9 @@
>  #define PCIE_CAP_CPL_TIMEOUT_DISABLE		0x10
>  
>  #define PCIE20_PARF_PHY_CTRL			0x40
> +#define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK	GENMASK(12, 16)
> +#define PHY_CTRL_PHY_TX0_TERM_OFFSET(x)		((x) << 16)
> +
>  #define PCIE20_PARF_PHY_REFCLK			0x4C
>  #define PHY_REFCLK_SSP_EN			BIT(16)
>  #define PHY_REFCLK_USE_PAD			BIT(12)
> @@ -118,6 +121,7 @@ struct qcom_pcie_resources_2_1_0 {
>  	u32 tx_swing_full;
>  	u32 tx_swing_low;
>  	u32 rx0_eq;
> +	u8 phy_tx0_term_offset;
>  };
>  
>  struct qcom_pcie_resources_1_0_0 {
> @@ -318,6 +322,11 @@ static int qcom_pcie_get_resources_2_1_0(struct qcom_pcie *pcie)
>  	if (IS_ERR(res->ext_reset))
>  		return PTR_ERR(res->ext_reset);
>  
> +	if (of_device_is_compatible(dev->of_node, "qcom,pcie-ipq8064"))
> +		res->phy_tx0_term_offset = 7;

Based on my other comments, you'll want to turn this into match data.

> +	else
> +		res->phy_tx0_term_offset = 0;
> +