Re: R: [PATCH v3 08/11] devicetree: bindings: pci: document PARF params bindings

From: Stanimir Varbanov
Date: Wed May 13 2020 - 07:43:28 EST




On 5/12/20 6:45 PM, Rob Herring wrote:
> On Thu, May 07, 2020 at 09:34:35PM +0200, ansuelsmth@xxxxxxxxx wrote:
>>> On Fri, May 01, 2020 at 12:06:15AM +0200, Ansuel Smith wrote:
>>>> It is now supported the editing of Tx De-Emphasis, Tx Swing and
>>>> Rx equalization params on ipq8064. Document this new optional params.
>>>>
>>>> Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
>>>> ---
>>>> .../devicetree/bindings/pci/qcom,pcie.txt | 36 +++++++++++++++++++
>>>> 1 file changed, 36 insertions(+)
>>>>
>>>> diff --git a/Documentation/devicetree/bindings/pci/qcom,pcie.txt
>>> b/Documentation/devicetree/bindings/pci/qcom,pcie.txt
>>>> index 6efcef040741..8cc5aea8a1da 100644
>>>> --- a/Documentation/devicetree/bindings/pci/qcom,pcie.txt
>>>> +++ b/Documentation/devicetree/bindings/pci/qcom,pcie.txt
>>>> @@ -254,6 +254,42 @@
>>>> - "perst-gpios" PCIe endpoint reset signal line
>>>> - "wake-gpios" PCIe endpoint wake signal line
>>>>
>>>> +- qcom,tx-deemph-gen1:
>>>> + Usage: optional (available for ipq/apq8064)
>>>> + Value type: <u32>
>>>> + Definition: Gen1 De-emphasis value.
>>>> + For ipq806x should be set to 24.
>>>
>>> Unless these need to be tuned per board, then the compatible string for
>>> ipq806x should imply all these settings.
>>>
>>
>> It was requested by v2 to make this settings tunable. These don't change are
>> all the same for every ipq806x SoC. The original implementation had this
>> value hardcoded for ipq806x. Should I restore this and drop this patch?
>
> Yes, please.

I still think that the values for tx deemph and tx swing should be
tunable. But I can live with them in the driver if they not break
support for apq8064.

The default values in the registers for apq8064 and ipq806x are:

default your change
TX_DEEMPH_GEN1 21 24
TX_DEEMPH_GEN2_3_5DB 21 24
TX_DEEMPH_GEN2_6DB 32 34

TX_SWING_FULL 121 120
TX_SWING_LOW 121 120

So until now (without your change) apq8064 worked with default values.

>
> Rob
>

--
regards,
Stan