Re: [PATCH v5 2/6] spi: spi-geni-qcom: Use OPP API to set clk/perf state

[Bjorn Andersson]

On Wed 13 May 22:03 PDT 2020, Rajendra Nayak wrote:

> 
> []..
> 
> > >   	spi->bus_num = -1;
> > >   	spi->dev.of_node = dev->of_node;
> > > @@ -596,6 +607,9 @@ static int spi_geni_probe(struct platform_device *pdev)
> > >   spi_geni_probe_runtime_disable:
> > >   	pm_runtime_disable(dev);
> > >   	spi_master_put(spi);
> > > +	if (mas->se.has_opp_table)
> > 
> > Why do you need has_opp_table?
> > 
> > Afaict if dev_pm_opp_of_add_table() returns -ENODEV there's no attached
> > opp-table and dev_pm_opp_of_remove_table() is a nop.
> 
> Apparently its not. Calling dev_pm_opp_of_remove_table() when dev_pm_opp_of_add_table()
> failed causes use-count mismatch.
> You can see https://lkml.org/lkml/2020/4/15/18 for more details.
> 

Must have missed that when I glanced at the code, thanks for clarifying.

Regards,
Bjorn

> -- 
> QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
> of Code Aurora Forum, hosted by The Linux Foundation