Re: [PATCH v3 3/5] serial: 8250: Support separate rs485 rx-enable GPIO

[Andy Shevchenko]

On Sun, May 17, 2020 at 11:56:08PM +0200, Heiko Stuebner wrote:
> From: Heiko Stuebner <heiko.stuebner@xxxxxxxxxxxxxxxxxxxxx>
> 
> The RE signal is used to control the duplex mode of transmissions,
> aka receiving data while sending in full duplex mode, while stopping
> receiving data in half-duplex mode.
> 
> On a number of boards the !RE signal is tied to ground so reception
> is always enabled except if the UART allows disabling the receiver.
> This can be taken advantage of to implement half-duplex mode - like
> done on 8250_bcm2835aux.
> 
> Another solution is to tie !RE to RTS always forcing half-duplex mode.
> 
> And finally there is the option to control the RE signal separately,
> like done here by introducing a new rs485-specific gpio that can be
> set depending on the RX_DURING_TX setting in the common em485 callbacks.

...

> +	port->rs485_re_gpio = devm_gpiod_get_optional(dev, "rs485-rx-enable",
> +						      GPIOD_OUT_HIGH);

While reviewing some other patch I realized that people are missing the point
of these GPIO flags when pin is declared to be output.

HIGH here means "asserted" (consider active-high vs. active-low in general). Is
that the intention here?

Lukas, same question to your patch.

-- 
With Best Regards,
Andy Shevchenko