Re: RTL8723BS driver doesn't work for,me but I can help testing

[Tobias Baumann]

good morning

i got the new image from oleg(balbes150) 20200518 RC5Â and some more 
feedback

with my patch and oleg RC5 hotstart(shutdown now)Â do not work with my 
box ( wlan goes back to sleep mode always)

with my patch chance 1 of 5 till 1 of 3 that my wlan is up and not 
sleep from cold start

with oleg chance 1 of 2 till 1of 3 from cold start that wlan is up . 
(maybe because of phandle order?)

i thing there is maybe a timming problem between wlan dis , sdio data 
and host wake up wlan .

it could be that GPIOAO_6 is the host wake up wlan ? is it possible to 
change the activation order for the gpio pins by change it in dts ?

Tobias



Am 18.05.2020 um 22:37 schrieb Martin Blumenstingl:
> Hi Tobias,
>
> On Mon, May 18, 2020 at 7:59 AM Tobias Baumann <017623705678@xxxxxxxxxxx> wrote:
> > hi martin
> >
> > i activate your patch ; wlan works ;  also with only  edit GPIOX_11 wlan
> > works
> >
> > its now GPIO-402 out high ACTIVE_LOW  ( 3.3V on pin12)
> great, thank you for doing the research!
>
> did you find out if GPIOAO_6 is needed at all?
> the 3.10 kernel enables it and sets it to HIGH. my understanding is
> that you didn't change this one so the output is still LOW.
> so I'm wondering if it is needed at all (I wouldn't be surprised if it
> was not needed, these 3.10 kernel .dts files seem to be copy&pasted
> from various vendors and do not necessarily reflect the actual
> hardware setup inside the box)
>
> > i also attached the performance infos  Wlan0->Router and RAM->SDHC
> that's pretty good, great to see that it works fine for you :-)
>
>
> Martin

--
Diese E-Mail wurde von AVG auf Viren geprÃft.
http://www.avg.com