Re: [RFC PATCH v3 2/2] CPPC: add support for SW BOOST

[Viresh Kumar]

On 19-05-20, 19:41, Xiongfeng Wang wrote:
> To add SW BOOST support for CPPC, we need to get the max frequency of
> boost mode and non-boost mode. ACPI spec 6.2 section 8.4.7.1 describe
> the following two CPC registers.
> 
> "Highest performance is the absolute maximum performance an individual
> processor may reach, assuming ideal conditions. This performance level
> may not be sustainable for long durations, and may only be achievable if
> other platform components are in a specific state; for example, it may
> require other processors be in an idle state.
> 
> Nominal Performance is the maximum sustained performance level of the
> processor, assuming ideal operating conditions. In absence of an
> external constraint (power, thermal, etc.) this is the performance level
> the platform is expected to be able to maintain continuously. All
> processors are expected to be able to sustain their nominal performance
> state simultaneously."
> 
> To add SW BOOST support for CPPC, we can use Highest Performance as the
> max performance in boost mode and Nominal Performance as the max
> performance in non-boost mode. If the Highest Performance is greater
> than the Nominal Performance, we assume SW BOOST is supported.
> 
> The current CPPC driver does not support SW BOOST and use 'Highest
> Performance' as the max performance the CPU can achieve. 'Nominal
> Performance' is used to convert 'performance' to 'frequency'. That
> means, if firmware enable boost and provide a value for Highest
> Performance which is greater than Nominal Performance, boost feature is
> enabled by default.
> 
> Because SW BOOST is disabled by default, so, after this patch, boost
> feature is disabled by default even if boost is enabled by firmware.
> 
> Signed-off-by: Xiongfeng Wang <wangxiongfeng2@xxxxxxxxxx>
> ---
>  drivers/cpufreq/cppc_cpufreq.c | 39 +++++++++++++++++++++++++++++++++++++--
>  1 file changed, 37 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/cpufreq/cppc_cpufreq.c b/drivers/cpufreq/cppc_cpufreq.c
> index bda0b24..792ed9e 100644
> --- a/drivers/cpufreq/cppc_cpufreq.c
> +++ b/drivers/cpufreq/cppc_cpufreq.c
> @@ -37,6 +37,7 @@
>   * requested etc.
>   */
>  static struct cppc_cpudata **all_cpu_data;
> +static bool boost_supported;
>  
>  struct cppc_workaround_oem_info {
>  	char oem_id[ACPI_OEM_ID_SIZE + 1];
> @@ -310,7 +311,7 @@ static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
>  	 * Section 8.4.7.1.1.5 of ACPI 6.1 spec)
>  	 */
>  	policy->min = cppc_cpufreq_perf_to_khz(cpu, cpu->perf_caps.lowest_nonlinear_perf);
> -	policy->max = cppc_cpufreq_perf_to_khz(cpu, cpu->perf_caps.highest_perf);
> +	policy->max = cppc_cpufreq_perf_to_khz(cpu, cpu->perf_caps.nominal_perf);
>  
>  	/*
>  	 * Set cpuinfo.min_freq to Lowest to make the full range of performance
> @@ -318,7 +319,7 @@ static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
>  	 * nonlinear perf
>  	 */
>  	policy->cpuinfo.min_freq = cppc_cpufreq_perf_to_khz(cpu, cpu->perf_caps.lowest_perf);
> -	policy->cpuinfo.max_freq = cppc_cpufreq_perf_to_khz(cpu, cpu->perf_caps.highest_perf);
> +	policy->cpuinfo.max_freq = cppc_cpufreq_perf_to_khz(cpu, cpu->perf_caps.nominal_perf);
>  
>  	policy->transition_delay_us = cppc_cpufreq_get_transition_delay_us(cpu_num);
>  	policy->shared_type = cpu->shared_type;
> @@ -343,6 +344,13 @@ static int cppc_cpufreq_cpu_init(struct cpufreq_policy *policy)
>  
>  	cpu->cur_policy = policy;
>  
> +	/*
> +	 * If 'highest_perf' is greater than 'nominal_perf', we assume CPU Boost
> +	 * is supported.
> +	 */
> +	if (cpu->perf_caps.highest_perf > cpu->perf_caps.nominal_perf)
> +		boost_supported = true;
> +
>  	/* Set policy->cur to max now. The governors will adjust later. */
>  	policy->cur = cppc_cpufreq_perf_to_khz(cpu,
>  					cpu->perf_caps.highest_perf);
> @@ -410,6 +418,32 @@ static unsigned int cppc_cpufreq_get_rate(unsigned int cpunum)
>  	return cppc_get_rate_from_fbctrs(cpu, fb_ctrs_t0, fb_ctrs_t1);
>  }
>  
> +static int cppc_cpufreq_set_boost(struct cpufreq_policy *policy, int state)
> +{
> +	struct cppc_cpudata *cpudata;
> +	int ret = 0;

No need to initialize this.

> +
> +	if (!boost_supported) {
> +		pr_err("BOOST not supported by CPU or firmware\n");
> +		return -EINVAL;
> +	}
> +
> +	cpudata = all_cpu_data[policy->cpu];
> +	if (state)
> +		policy->max = cppc_cpufreq_perf_to_khz(cpudata,
> +					cpudata->perf_caps.highest_perf);
> +	else
> +		policy->max = cppc_cpufreq_perf_to_khz(cpudata,
> +					cpudata->perf_caps.nominal_perf);
> +	policy->cpuinfo.max_freq = policy->max;
> +
> +	ret = freq_qos_update_request(policy->max_freq_req, policy->max);
> +	if (ret < 0)
> +		return ret;
> +
> +	return 0;
> +}
> +
>  static struct cpufreq_driver cppc_cpufreq_driver = {
>  	.flags = CPUFREQ_CONST_LOOPS,
>  	.verify = cppc_verify_policy,
> @@ -417,6 +451,7 @@ static unsigned int cppc_cpufreq_get_rate(unsigned int cpunum)
>  	.get = cppc_cpufreq_get_rate,
>  	.init = cppc_cpufreq_cpu_init,
>  	.stop_cpu = cppc_cpufreq_stop_cpu,
> +	.set_boost = cppc_cpufreq_set_boost,
>  	.name = "cppc_cpufreq",
>  };
>  
> -- 
> 1.7.12.4

-- 
viresh