Re: [PATCH v2 06/12] i2c: designware: slave: Set DW I2C core module dependency

[Jarkko Nikula]

On 5/10/20 12:50 PM, Serge Semin wrote:
> DW APB I2C slave code in fact depends on the DW I2C driver core, but not
> on the platform code. Yes, the I2C slave interface is currently supported
> by the platform version of the IP core, but it doesn't make it dependent
> on it. So make sure the DW APB I2C slave config is only available if the
> I2C_DESIGNWARE_CORE config is enabled.
>
> Signed-off-by: Serge Semin <Sergey.Semin@xxxxxxxxxxxxxxxxxxxx>
> Cc: Alexey Malahov <Alexey.Malahov@xxxxxxxxxxxxxxxxxxxx>
> Cc: Thomas Bogendoerfer <tsbogend@xxxxxxxxxxxxxxxx>
> Cc: Paul Burton <paulburton@xxxxxxxxxx>
> Cc: Ralf Baechle <ralf@xxxxxxxxxxxxxx>
> Cc: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
> Cc: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
> Cc: Wolfram Sang <wsa@xxxxxxxxxxxxx>
> Cc: Rob Herring <robh+dt@xxxxxxxxxx>
> Cc: Frank Rowand <frowand.list@xxxxxxxxx>
> Cc: linux-mips@xxxxxxxxxxxxxxx
> Cc: devicetree@xxxxxxxxxxxxxxx
> ---
>   drivers/i2c/busses/Kconfig | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
Acked-by: Jarkko Nikula <jarkko.nikula@xxxxxxxxxxxxxxx>