Re: [RFC 03/11] net: phy: refactor c45 phy identification sequence

From: Jeremy Linton
Date: Sat May 23 2020 - 13:16:26 EST


Hi,

Thanks for taking a look at this!

On 5/23/20 10:28 AM, Andrew Lunn wrote:
On Fri, May 22, 2020 at 04:30:51PM -0500, Jeremy Linton wrote:
Lets factor out the phy id logic, and make it generic
so that it can be used for c22 and c45.

Signed-off-by: Jeremy Linton <jeremy.linton@xxxxxxx>
---
drivers/net/phy/phy_device.c | 65 +++++++++++++++++++-----------------
1 file changed, 35 insertions(+), 30 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 7746c07b97fe..f0761fa5e40b 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -695,6 +695,29 @@ static int get_phy_c45_devs_in_pkg(struct mii_bus *bus, int addr, int dev_addr,
return 0;
}
+static int _get_phy_id(struct mii_bus *bus, int addr, int dev_addr,
+ u32 *phy_id, bool c45)

Hi Jeremy

How about read_phy_id() so you can avoid the _ prefix.

Yes, that sounds good.


static bool valid_phy_id(int val)
{
return (val > 0 && ((val & 0x1fffffff) != 0x1fffffff));
@@ -715,17 +738,17 @@ static bool valid_phy_id(int val)
*/
static int get_phy_c45_ids(struct mii_bus *bus, int addr, u32 *phy_id,
struct phy_c45_device_ids *c45_ids) {
- int phy_reg;
- int i, reg_addr;
+ int ret;
+ int i;
const int num_ids = ARRAY_SIZE(c45_ids->device_ids);
u32 *devs = &c45_ids->devices_in_package;
/* Find first non-zero Devices In package. Device zero is reserved
* for 802.3 c45 complied PHYs, so don't probe it at first.
*/
- for (i = 1; i < num_ids && *devs == 0; i++) {
- phy_reg = get_phy_c45_devs_in_pkg(bus, addr, i, devs);
- if (phy_reg < 0)
+ for (i = 0; i < num_ids && *devs == 0; i++) {
+ ret = get_phy_c45_devs_in_pkg(bus, addr, i, devs);
+ if (ret < 0)
return -EIO;

Renaming reg_addr to ret does not belong in this patch.

Sure, that makes sense. The rename was a last min change when I was shuffling the args around.

Thanks,