[PATCH v25 05/16] dt: bindings: lp55xx: Be consistent in the document with LED acronym

[Dan Murphy]

Update the document to be consistent in case when using "LED".
This acronym should be capital throughout the document.

Acked-by: Pavel Machek <pavel@xxxxxx>
Acked-by: Jacek Anaszewski <jacek.anaszewski@xxxxxxxxx>
Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
---
 Documentation/devicetree/bindings/leds/leds-lp55xx.txt | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
index 1b66a413fb9d..bfe2805c5534 100644
--- a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
+++ b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
@@ -1,4 +1,4 @@
-Binding for TI/National Semiconductor LP55xx Led Drivers
+Binding for TI/National Semiconductor LP55xx LED Drivers
 
 Required properties:
 - compatible: one of
@@ -12,8 +12,8 @@ Required properties:
 - clock-mode: Input clock mode, (0: automode, 1: internal, 2: external)
 
 Each child has own specific current settings
-- led-cur: Current setting at each led channel (mA x10, 0 if led is not connected)
-- max-cur: Maximun current at each led channel.
+- led-cur: Current setting at each LED channel (mA x10, 0 if LED is not connected)
+- max-cur: Maximun current at each LED channel.
 
 Optional properties:
 - enable-gpio: GPIO attached to the chip's enable pin
-- 
2.25.1