[PATCH V7 3/3] dt-bindings: serial: Add binding for UART pin swap

[Akash Asthana]

Add documentation to support RX-TX & CTS-RTS GPIO pin swap in HW.

Signed-off-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
---
Changes in V7:
 - As per Rob's comment, added type: boolean to properties.

 Documentation/devicetree/bindings/serial/serial.yaml | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/serial/serial.yaml b/Documentation/devicetree/bindings/serial/serial.yaml
index 53204d9..8645d0e 100644
--- a/Documentation/devicetree/bindings/serial/serial.yaml
+++ b/Documentation/devicetree/bindings/serial/serial.yaml
@@ -67,6 +67,14 @@ properties:
       (wired and enabled by pinmux configuration).  This depends on both the
       UART hardware and the board wiring.
 
+  rx-tx-swap:
+    type: boolean
+    description: RX and TX pins are swapped.
+
+  cts-rts-swap:
+    type: boolean
+    description: CTS and RTS pins are swapped.
+
 if:
   required:
     - uart-has-rtscts
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project