Re: [PATCH v4] bluetooth: hci_qca: Fix qca6390 enable failure after warm reboot

From: Zijun Hu
Date: Thu May 28 2020 - 05:18:50 EST




On 5/28/2020 4:19 PM, Marcel Holtmann wrote:
> Hi Zijun,
>
>> Warm reboot can not restore qca6390 controller baudrate
>> to default due to lack of controllable BT_EN pin or power
>> supply, so fails to download firmware after warm reboot.
>>
>> Fixed by sending EDL_SOC_RESET VSC to reset controller
>> within added device shutdown implementation.
>>
>> Signed-off-by: Zijun Hu <zijuhu@xxxxxxxxxxxxxx>
>> ---
>> drivers/bluetooth/hci_qca.c | 33 +++++++++++++++++++++++++++++++++
>> 1 file changed, 33 insertions(+)
>>
>> diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
>> index e4a6823..8e03bfe 100644
>> --- a/drivers/bluetooth/hci_qca.c
>> +++ b/drivers/bluetooth/hci_qca.c
>> @@ -1975,6 +1975,38 @@ static void qca_serdev_remove(struct serdev_device *serdev)
>> hci_uart_unregister_device(&qcadev->serdev_hu);
>> }
>>
>> +static void qca_serdev_shutdown(struct device *dev)
>> +{
>> + int ret;
>> + int timeout = msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS);
>> + struct serdev_device *serdev = to_serdev_device(dev);
>> + struct qca_serdev *qcadev = serdev_device_get_drvdata(serdev);
>> + const u8 ibs_wake_cmd[] = { 0xFD };
>> + const u8 edl_reset_soc_cmd[] = { 0x01, 0x00, 0xFC, 0x01, 0x05 };
>
> struct hci_dev *hdev = container_of(dev, struct hci_dev, dev);
> no.
this dev is serdev_device not hci_dev
>> +
>> + if (qcadev->btsoc_type == QCA_QCA6390) {
>> + serdev_device_write_flush(serdev);
>> + ret = serdev_device_write_buf(serdev,
>> + ibs_wake_cmd, sizeof(ibs_wake_cmd));
>> + if (ret < 0) {
>> + BT_ERR("QCA send IBS_WAKE_IND error: %d", ret);
>
> And then use bt_dev_err here.
as explained above about dev, bt_dev_err is not a good selection at
this serdev_device shudown operation.
>
>> + return;
>> + }
>> + serdev_device_wait_until_sent(serdev, timeout);
>> + usleep_range(8000, 10000);
>> +
>> + serdev_device_write_flush(serdev);
>> + ret = serdev_device_write_buf(serdev,
>> + edl_reset_soc_cmd, sizeof(edl_reset_soc_cmd));
>> + if (ret < 0) {
>> + BT_ERR("QCA send EDL_RESET_REQ error: %d", ret);
>> + return;
>> + }
>> + serdev_device_wait_until_sent(serdev, timeout);
>> + usleep_range(8000, 10000);
>> + }
>> +}
>> +
>> static int __maybe_unused qca_suspend(struct device *dev)
>> {
>> struct hci_dev *hdev = container_of(dev, struct hci_dev, dev);
>> @@ -2100,6 +2132,7 @@ static struct serdev_device_driver qca_serdev_driver = {
>> .name = "hci_uart_qca",
>> .of_match_table = of_match_ptr(qca_bluetooth_of_match),
>> .acpi_match_table = ACPI_PTR(qca_bluetooth_acpi_match),
>> + .shutdown = qca_serdev_shutdown,
>> .pm = &qca_pm_ops,
>> },
>> };
>
> Regards
>
> Marcel
>

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project