Re: [PATCH RFT] ravb: Mask PHY mode to avoid inserting delays twice

[Florian Fainelli]

On 5/29/2020 5:25 AM, Geert Uytterhoeven wrote:
> Until recently, the Micrel KSZ9031 PHY driver ignored any PHY mode
> ("RGMII-*ID") settings, but used the hardware defaults, augmented by
> explicit configuration of individual skew values using the "*-skew-ps"
> DT properties.  The lack of PHY mode support was compensated by the
> EtherAVB MAC driver, which configures TX and/or RX internal delay
> itself, based on the PHY mode.
> 
> However, now the KSZ9031 driver has gained PHY mode support, delays may
> be configured twice, causing regressions.  E.g. on the Renesas
> Salvator-X board with R-Car M3-W ES1.0, TX performance dropped from ca.
> 400 Mbps to 0.1-0.3 Mbps, as measured by nuttcp.
> 
> As internal delay configuration supported by the KSZ9031 PHY is too
> limited for some use cases, the ability to configure MAC internal delay
> is deemed useful and necessary.  Hence a proper fix would involve
> splitting internal delay configuration in two parts, one for the PHY,
> and one for the MAC.  However, this would require adding new DT
> properties, thus breaking DTB backwards-compatibility.
> 
> Hence fix the regression in a backwards-compatibility way, by letting
> the EtherAVB driver mask the PHY mode when it has inserted a delay, to
> avoid the PHY driver adding a second delay.  This also fixes messages
> like:
> 
>     Micrel KSZ9031 Gigabit PHY e6800000.ethernet-ffffffff:00: *-skew-ps values should be used only with phy-mode = "rgmii"
> 
> as the PHY no longer sees the original RGMII-*ID mode.
> 
> Solving the issue by splitting configuration in two parts can be handled
> in future patches, and would require retaining a backwards-compatibility
> mode anyway.
> 
> Fixes: bcf3440c6dd78bfe ("net: phy: micrel: add phy-mode support for the KSZ9031 PHY")
> Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>

Reviewed-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
-- 
Florian