[PATCH 2/2] riscv: Use PUD/PGDIR entries for linear mapping when possible
From: Alexandre Ghiti
Date: Wed Jun 03 2020 - 11:38:23 EST
Improve best_map_size so that PUD or PGDIR entries are used for linear
mapping when possible as it allows better TLB utilization.
Signed-off-by: Alexandre Ghiti <alex@xxxxxxxx>
---
arch/riscv/mm/init.c | 45 +++++++++++++++++++++++++++++++++-----------
1 file changed, 34 insertions(+), 11 deletions(-)
diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
index 9a5c97e091c1..d275f9f834cf 100644
--- a/arch/riscv/mm/init.c
+++ b/arch/riscv/mm/init.c
@@ -424,13 +424,29 @@ static void __init create_pgd_mapping(pgd_t *pgdp,
create_pgd_next_mapping(nextp, va, pa, sz, prot);
}
-static uintptr_t __init best_map_size(phys_addr_t base, phys_addr_t size)
+static bool is_map_size_ok(uintptr_t map_size, phys_addr_t base,
+ uintptr_t base_virt, phys_addr_t size)
{
- /* Upgrade to PMD_SIZE mappings whenever possible */
- if ((base & (PMD_SIZE - 1)) || (size & (PMD_SIZE - 1)))
- return PAGE_SIZE;
+ return !((base & (map_size - 1)) || (base_virt & (map_size - 1)) ||
+ (size < map_size));
+}
+
+static uintptr_t __init best_map_size(phys_addr_t base, uintptr_t base_virt,
+ phys_addr_t size)
+{
+#ifndef __PAGETABLE_PMD_FOLDED
+ if (is_map_size_ok(PGDIR_SIZE, base, base_virt, size))
+ return PGDIR_SIZE;
+
+ if (pgtable_l4_enabled)
+ if (is_map_size_ok(PUD_SIZE, base, base_virt, size))
+ return PUD_SIZE;
+#endif
+
+ if (is_map_size_ok(PMD_SIZE, base, base_virt, size))
+ return PMD_SIZE;
- return PMD_SIZE;
+ return PAGE_SIZE;
}
/*
@@ -576,7 +592,7 @@ void create_kernel_page_table(pgd_t *pgdir, uintptr_t map_size)
asmlinkage void __init setup_vm(uintptr_t dtb_pa)
{
uintptr_t va, end_va;
- uintptr_t map_size = best_map_size(load_pa, MAX_EARLY_MAPPING_SIZE);
+ uintptr_t map_size;
load_pa = (uintptr_t)(&_start);
load_sz = (uintptr_t)(&_end) - load_pa;
@@ -587,6 +603,7 @@ asmlinkage void __init setup_vm(uintptr_t dtb_pa)
kernel_virt_addr = KERNEL_VIRT_ADDR;
+ map_size = best_map_size(load_pa, PAGE_OFFSET, MAX_EARLY_MAPPING_SIZE);
va_pa_offset = PAGE_OFFSET - load_pa;
va_kernel_pa_offset = kernel_virt_addr - load_pa;
pfn_base = PFN_DOWN(load_pa);
@@ -700,6 +717,8 @@ static void __init setup_vm_final(void)
/* Map all memory banks */
for_each_memblock(memory, reg) {
+ uintptr_t remaining_size;
+
start = reg->base;
end = start + reg->size;
@@ -707,15 +726,19 @@ static void __init setup_vm_final(void)
break;
if (memblock_is_nomap(reg))
continue;
- if (start <= __pa(PAGE_OFFSET) &&
- __pa(PAGE_OFFSET) < end)
- start = __pa(PAGE_OFFSET);
- map_size = best_map_size(start, end - start);
- for (pa = start; pa < end; pa += map_size) {
+ pa = start;
+ remaining_size = reg->size;
+
+ while (remaining_size) {
va = (uintptr_t)__va(pa);
+ map_size = best_map_size(pa, va, remaining_size);
+
create_pgd_mapping(swapper_pg_dir, va, pa,
map_size, PAGE_KERNEL);
+
+ pa += map_size;
+ remaining_size -= map_size;
}
}
--
2.20.1