Re: [PATCH 1/2] dt-bindings: phy: add bcm63xx-usbh bindings

[Florian Fainelli]

On 6/17/2020 4:16 AM, Ãlvaro FernÃndez Rojas wrote:
>> On 6328, the same register space allows the controlling of the USB PHY
>> in either host or device mode, so I believe you would need to add a
>> #phy-cells = 1 in order to distinguish the consumer (host versus device)
>> if we get to the point where drivers/usb/gadget/udc/bcm63xx_udc.c
>> becomes DT aware.
> 
> Iâve just realized that I have implemented this wrong in v3, because I implemented the SwapControl USB_DEVICE_SEL value, and you meant the UTMIControl1 USB_DEVICE_MODE_SEL value.

Right that is the register I was referring to.

> So I have a couple of questions about this, because I havenât got any bcm63xx with usb device configuration to test:
> - Is USB_DEVICE_SEL also needed in SwapControl or do we only need USB_DEVICE_MODE_SEL in UTMIControl1?

It looks like it depends on the device, for 6318 and 63268, there is
USB_DEVICE_MODE_SEL defined, but not for 6328, 6362 or 6368 for
instance. Note that USB_DEVICE_MODE_SEL is relevant for port 2 only for
6318 and 63268 whereas the UTMI_CONTROL1 appears to be for any port.

> - Are the rest of the host values needed when configured in device mode? Should I only set the device values when in device mode?

They could probably be configured although I am not sure they sure they
will be used at all, it's been a while since I looked at this (over 8
years).

I don't know if you have any board with USB device mode capability, if
you do not please email privately and I will ship you one.
-- 
Florian