Re: [PATCH v3 6/6] arm64: boot: dts: qcom: pm8150b: Add DTS node for PMIC VBUS booster

[Bjorn Andersson]

On Wed 17 Jun 11:02 PDT 2020, Wesley Cheng wrote:

> Add the required DTS node for the USB VBUS output regulator, which is
> available on PM8150B.  This will provide the VBUS source to connected
> peripherals.
> 
> Signed-off-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/pm8150b.dtsi   | 6 ++++++
>  arch/arm64/boot/dts/qcom/sm8150-mtp.dts | 7 +++++++
>  2 files changed, 13 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/pm8150b.dtsi b/arch/arm64/boot/dts/qcom/pm8150b.dtsi
> index ec44a8bc2f84..b7274d9d7341 100644
> --- a/arch/arm64/boot/dts/qcom/pm8150b.dtsi
> +++ b/arch/arm64/boot/dts/qcom/pm8150b.dtsi
> @@ -22,6 +22,12 @@ power-on@800 {
>  			status = "disabled";
>  		};
>  
> +		qcom,dcdc@1100 {

You shouldn't use "qcom," in node names and whenever possible you should
try to use generic node names. It would also be good to have a label on
this, to allow the regulator to be referenced by a client.

So please make this something like:
		pm8150b_vbus: regulator@1100 {

> +			compatible = "qcom,pm8150b-vbus-reg";
> +			status = "disabled";
> +			reg = <0x1100>;
> +		};
> +
>  		qcom,typec@1500 {
>  			compatible = "qcom,pm8150b-usb-typec";
>  			status = "disabled";
> diff --git a/arch/arm64/boot/dts/qcom/sm8150-mtp.dts b/arch/arm64/boot/dts/qcom/sm8150-mtp.dts
> index 6c6325c3af59..3845d19893eb 100644
> --- a/arch/arm64/boot/dts/qcom/sm8150-mtp.dts
> +++ b/arch/arm64/boot/dts/qcom/sm8150-mtp.dts
> @@ -426,6 +426,13 @@ &usb_1 {
>  	status = "okay";
>  };
>  
> +&spmi_bus {
> +	pmic@2 {
> +		qcom,dcdc@1100 {
> +			status = "okay";
> +		};
> +};

And then you can enable &pm8150b_vbus here instead.

Regards,
Bjorn

> +
>  &usb_1_dwc3 {
>  	dr_mode = "peripheral";
>  };
> -- 
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> a Linux Foundation Collaborative Project
>